Invacare 1073955 manual Hand Activated Wheel Lock Procedures

SECTION 10—ANTI-TIPPERS/WHEEL LOCKS

Wheelchair

Frame

Wheel Lock

Clamp

Set Screws

FIGURE 10.1

Lower Tube of	Crossbar
Wheelchair
	Wheel Lock
Frame
	Clamp

Foot Activated	Slider	Release
Wheel Lock	Bar		Vertical Tube
Assembly		Lever

NOTE: A portion of the Release Lever is cut away to show a better view of the slider bar.

Foot Activated Wheel Lock Procedures

Hand Activated Wheel Lock Procedures

Installing/Removing Hand Activated Wheel Locks

NOTE: For this procedure, refer to FIGURE 10.3 on page 67.

1.Remove the foot activated wheel lock. Refer to Installing/Removing Foot Activated Wheel Locks on page 65.

2.Do one of the following:

•For 12‐inch Rear Wheels: Position the wheel lock assembly on the LOWER tube of the frame.

•For 20, 22, or 24‐inch Rear Wheels: Position the wheel lock assembly on the upper tube of frame.

3.Loosely tighten the two socket screws that secure the wheel locks to the wheelchair frame.

4.Adjust the wheel locks. Refer to Adjusting the Wheel Lock on page 67.

5.To remove the wheel locks, unthread the socket screws and remove wheel lock from the wheelchair frame.

12-inch Rear	Socket
	Screws
Wheel
	Hand
	Activated
	Wheel
	Lock

Lower Tube

of Frame

20, 22, 24-inch	Upper Tube
Rear Wheel	of Frame

FIGURE 10.2 Installing/Removing Hand

Activated Wheel Locks

Orbit™ 66 Part No. 1073955