SECTION
DETAIL “A” - |
| |
AXLE | ||
Axle | Head | |
Bushing | ||
Axle Mounting | End | |
Rear Wheel | ||
Plate | ||
| ||
|
| |
Locknut | Axle Mounting Plate |
DETAIL “B” -
Mounting Screw
PERMANENT Axle Bushing
AXLE
FIGURE 9.1 Removing/Installing Rear Wheels
Adjusting the Quick-Release Axle
NOTE: For this procedure, refer to FIGURE 9.2.
1.Remove rear wheel and quick‐release axle from the wheelchair. Refer to Removing/Installing Rear Wheels on page 61.
2.Depress detent pin (tip) in the quick‐release axle and slide axle through the wheel hub.
3.Release detent pin ensuring that the locking pins are fully released.
4.Increase or decrease end play by adjusting the locknut on the end of the quick‐release axle.
WARNING
Make sure the detent pin and locking pins of the
Keep locking pins clean.
5.Reinstall rear wheel onto wheelchair. Refer to Removing/Installing Rear Wheels on page 61.
Axle
MountingLocknut
Plate
Locking | Detent | |
Pin | ||
Pins | ||
| ||
Wheel Hub |