Invacare 1073955 manual Installing 3-Inch Extension

SECTION 5—FRONT RIGGINGS

WARNING Footrest Support

DO NOT overtighten. Footrest must be able to rotate upward from the horizon- tal to vertical position.

4.Reinstall the mounting screw through the mounting holes of the footplate and footrest support.

5.Secure the footplate to the footrest support with the coved washer and locknut. Securely tighten.

	Height
Locknut	Adjustment
	Holes
	Coved Washers
	Mounting
Footplate	Screw

FIGURE 5.3 Adjusting Footplate Height

(70° MFX and 90° Footrests Only)

Installing 3-Inch Extension

NOTE: For this procedure, refer to FIGURE 5.4.

NOTE: Note the mounting hole position of the mounting screw, washers, and locknut for proper reassembly of the footrest.

NOTE: If using ANY type of extension with the adjustable angle footplate, refer to Adjusting Perpendicular and/or Inversion/Eversion Adjustable Angle Flip‐up Footplate on page 35.

1.Remove any accessories that are attached to the footrests.

2.Remove the mounting screw, washer and locknut that secure the footplate to the footrest support.

3.Insert the 3‐inch extension into the footrest support and align the mounting holes.

4.Secure the 3‐inch extension to the footrest support with new mounting screw, washer and locknut.

5.Position the footplate at the desired height.

WARNING

DO NOT overtighten. Footrest must be able to rotate upward from the horizontal to vertical position.

6.Secure the footplate to the 3‐inch extension with the coved washer and locknut. Securely tighten.

Locknut	Washer
Footrest Support	Mounting
	screw
3-inch	Mounting Screw,
	Coved Washer
Extension
	and Locknut

Footplate

FIGURE 5.4 Installing 3-Inch Extension

Orbit™ 32 Part No. 1073955