SECTION
Footrest Support | Front View of | |
Footplate and | ||
| ||
| Footrest | |
Footplate | Support | |
|
FIGURE 5.8 Adjusting Depth on Adjustable Angle Flip-Up - Adjusting Angle on Adjustable
Angle Flip-up Footplate
Adjusting Perpendicular and/or Inversion/Eversion Adjustable Angle
NOTE: For this procedure, refer to FIGURE 5.9.
NOTE: It is not necessary to remove the footplate to perform this adjustment.
1.Insert a flathead screwdriver through the half clamp on the adjustable angle footplate.
2.Slowly turn the nylon adjustment screw in or out until the adjustable angle footplate is perpendicular to the footrest assembly or the desired inversion or eversion is obtained.
Footrest | Side View Of | |
Footplate and | ||
Support | ||
Footrest | ||
| ||
Footplate |
|
FIGURE 5.9 Adjusting Perpendicular and/or Inversion/Eversion Adjustable Angle Flip-up Footplate
Bilateral Contracture Platform Procedures
WARNING
The footrest assembly MUST be at least
NOTE: For this procedure, refer to FIGURE 5.10 on page 36.
Installing Bilateral Contracture Platform
NOTE: If a seating system is being used on the chair, refer to the seating system Ownerʹs Manual for installation and removal of the seating system.
1.Remove the existing seating system from the wheelchair, if so equipped.
2.Remove existing footrest from the wheelchair. Refer to Installing/Removing Front Riggings on page 30.
3.Remove the telescoping tubes from the wheelchair. Refer to Installing/Removing/Adjusting the Telescoping Front Frame Tubes on page 38.