Panasonic MC-V325 manuel dutilisation Replacing Belt, Motor Shaft

Page 32

Replacing Belt

Lift

Agitator Up

Soulever l’agitateur

Unidad del agitador

Motor Shaft

 

Arbre d’entraînement

du moteur

Install

Eje del motor

New Belt

 

 

Poser la nouvelle

 

courroie

 

Instalación de la correa

 

End Cap

Groove

Bouchon

Tapa del

Ouverture

extremo

Ranura

 

Replace belt whenever a burning rubber smell caused by excessive slippage occurs.

Remove lower plate.

Remove agitator by carefully lifting out.

Remove worn or broken belt.

Clean agitator.

Loop new belt (Panasonic Type UB8 only) around motor shaft and agitator pulley; see illustration for correct belt routing.

Reinstall agitator back into nozzle housing grooves.

After reinstalling the agitator, turn it by hand to make sure that belt is not twisted or pinched and that all rotating parts turn freely.

Reinstall lower plate.

- 32 -

Image 32
Contents MC-V325 Consumer Information Avertissement Advertencia Important Safety Instructions Conserver ce manuel d’utilisation Advertencia Table of Contents Table des matières Tabla de contenido Grounding Instructions Avertissement Parts Identification NomenclatureFeature Chart Assembly Attaching HandleMontage du manche Colocación del mangoTool Storage Rangement des accessoires Almacenaje de herramientasMotor Protector Edge CleaningCarpet Height Selector Protector de motor Selector para el nivel de alfombraLimpieza para orillas ON-OFF Switch Handle AdjustmentsInterrupteur Control ON-OFFRéglage de l’inclinaison du manche Ajustes del mangoUsing Tools Utilisation des accessoires Uso de herramientasCleaning Secondary Foam Filter Tool UsageLimpieza del segundo filtro De goma espuma Emploi des accessoiresNettoyage du filtre secondaire En mousse Replacing Hepa Exhaust Filter Remplacement du filtre d’évacuation Hepa Cambiando el filtro de escape HepaChanging Dust Bag Remplacement du sac à poussière Cambio de la bolsa para polvoRemoving and Installing Lower Plate Enlèvement et installation de la Plaque inférieure Quitar y ensamblar la base inferiorReplacing Belt Motor ShaftLimpieza del agitador Remplacement de la courroieCambio de la correa Replacing Agitator Cleaning AgitatorAgitator Assembly Remplacement de l’agitateur Nettoyage de l’agitateurCambio del agitador Assemblage de l’agitateur / Montaje de agitadorCleaning Exterior and Tools Nettoyage du boîtier et des accessoires Limpieza del exterior y de los HerramientasRemoving Clogs Dégagement des obstructions Quitando los residuos de basura en Los conductosBefore Requesting Service Avertissement Antes de pedir servicio Warranty Warranty Garantie Garantía Page Cuando necesita servicio