off
1
2
off
1
old new
Quick cleaning
Press the foil release buttons (12) to lift the shaver foil (do not remove the foil completely). Switch on the shaver for approx.
Thorough manual cleaning
Manual cleaning is recommended only when the Clean&Charge station is not available, e.g. when travel- ling. Never use water to clean the shaver.
Remove the shaver foil and tap it out on a flat surface. Using the brush, clean the cutter block and the inner area of the pivoting head. If you do not use the Clean&Charge station for a longer period of time, you should apply a drop of light machine oil onto the shaver foil.
Replacing the cartridge
After having pressed the lift button (4) to open the housing, wait for a few seconds before removing the used cartridge.
Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution.
Cleaning the housing
Clean the housing of shaver and station from time to time with a damp cloth, especially inside the opening of the station where the shaver rests.
Shaver display
1.Pilot light: the shaver is connected to the mains.
2.Shaver is charging / Remaining charging time.
3.Self testing / shaver is fully charged (a full charge will give up to 50 minutes of cordless shaving time, depending on your beard growth).
8