Invacare 1106628 manual Using the Telescoping Back Canes Figure, Raising/Lowering, Storing, Open

Page 37

BACK/SEAT

PROCEDURE 6

 

 

USING THE TELESCOPING BACK CANES (FIGURE 5)

RAISING/LOWERING

1.Lift up the lever securing the telescoping back cane.

2.If back canes are completely lowered and handle is folded against the back, rotate the telescoping back cane until it stops.

3.Raise/lower the cane handle to the desired height.

4.Push down to close the lever and secure the telescoping back cane.

5.Push down on back cane to ensure levers hold the desired position of the back cane.

6.If levers do not hold the position, tighten the lever by performing the following:

A.Flip lever to the unlocked position.

B.Rotate thumbscrew CLOCKWISE one (1) revolution.

NOTE: When tightening the lever, the lever must be able to close completely into the locked position. Otherwise, the levers will not hold the desired angle.

C. Flip levers to the locked position.

NOTE: If the levers do not close completely into the locked position, rotate the thumbscrew on each lever COUNTERCLOCKWISE 1/2 revolution.

D.Repeat STEPS A-C for opposite lever.

E.Push down on back cane to ensure levers hold the desired position of the back cane.

F.Repeat STEPS A-E until levers hold the desired position.

STORING

1.Lift up the lever securing the telescoping back cane.

2.Lower the telescoping back cane.

3.Rotate the cane handle until folded against the back.

4.Push down to close the lever and secure the telescoping back cane.

OPEN

POSITIONThumbscrew

Lever

CLOSED

POSITION

FIGURE 5 - USING THE TELESCOPING BACK CANES

BACK/SEAT

Part No. 1106628

37

Solara jr.™

Page 36 Page 38
Image 37
Page 36 Page 38
Contents Solara jr Solara jr Table of Contents Procedure 8 Wheel LOCKS/ANTI-TIPPERS Special Notes Special NotesLabel Locations Label LocationsSpecifications SpecificationsInvacare Solara JR Information for Healthcare PROFESSIONALS/ Assistants Procedure General GuidelinesGeneral Guidelines Anterior Forward TiltStability ALL Models Except Recliners Stability ALL ModelsStability Warning Operating Information Stability Recliner Models onlyGeneral Warnings Weight Limitation Weight TrainingStability and Balance SAFETY/HANDLING of WheelchairsCoping with Everyday Obstacles Unoccupied Occupied Percentage of Weight DistributionMethod 1 Wheelchair with Step Tubes TippingStep Tube Tipping Curbs Method 2 Wheelchair Without Step Tube StairwaysTransferring to and from Other Seats ESCALATORS? SorrySafety Inspection Safety Inspection ChecklistMaintenance TroubleshootingProcedure 2SAFETY Inspection Maintenance Safety PrecautionsTransporting the Invacare Solara JR Transporting ProcedureTransporting Procedure Front Riggings INSTALLING/REMOVING Swingaway Footrest FigureFront Friggings RemovingFront Riggings Procedure Adjusting Swingaway Footrest HeightHeight Adjustment Ranges Front RiggingsAdjusting Adjustable Angle FLIP-UP Footplates Figure Composite Footplate Disassembly Front RiggingsprocedureReassembly Articulating Footplate Heel Loop ReplacementAdjusting the Legrest Adjusting the Elevating LEGREST/CALFPAD Assembly FigureAdjusting the Calfpad CalfpadARMS/POSITIONING Straps USING/ADJUSTING Dual Point Arms FigureReplacing Dual Point ARM PAD Figure Procedure ARMS/POSITIONING StrapsReplacing Dual Point ARM Clothing Guards Figure Using Figure USING/INSTALLING/ADJUSTING Cantilever ArmsINSTALLING/ADJUSTING ARM PAD Replacement for Cantilever Arms Figure Adjusting the T-ARMS INSTALLING/REMOVING T-ARMS FigureInstalling T-ARMS Adjusting T-ARM Height FigureInside T-Arm Post Arm Release Lever Locked Position DepthOutside T- Arm Post SocketAdjusting T-ARM Sockets Figure Adjusting T-ARM Transfer Assists AND/OR Side Guards FigureHex screws and washers are removed Arm Arm Clamp Slot Arm SocketReplacing INSTALLING/REPLACING Seat Positioning Straps FigureSide Guard Transfer Assist Socket ScrewsBack Cane Locknut Hex Screw Chest Positioning Strap INSTALLING/REPLACING Chest Positioning Straps FigureINSTALLING/REMOVING Stroller Handles Figure FOLDING/UNFOLDING Back Assembly FigureBACK/SEAT Detail a QUICK-RELEASE PIN Installed Installing FigureRemoving Figure Quick-Release Pin Or bolt and locknut Recliners onlyLocked Position Procedure BACK/SEAT Adjusting FigureStroller Handle Thumbscrew Release Lever RAISING/LOWERING Using the Telescoping Back Canes FigureStoring OpenFixed Back Canes Figure INSTALLING/REPLACING the Back UpholsteryREMOVING/INSTALLING the Spreader BAR Figure Installing and Removing a Seating SystemClamp Spreader Bar Set Screw Back Canes Rear Installing the Seat Cushion FigureWheelchair Front WHEELS/FORKS Procedure REMOVING/INSTALLING Rear Wheels FigureWHEELS/FORKS Quick Release AxleSEAT-TO-FLOOR Height Adjustment Adjusting the Quick Release Axle FigureProcedure WHEELS/FORKS Axle Mounting Plate Locking PinsFork Dust Cover Caster Headtube Adjusting Forks FigureProcedure Wheel LOCKS/ANTI-TIPPERS Adjusting Wheel Locks Figures 1Wheel TIPPERS-LOCKS/ANTI 16-INCH Rear Wheels 18 24-INCH Rear WheelsFoot Activated Wheel Locks 12-INCH Wheels only Figure Using the Wheel LocksWheel LOCKS/ANTI-TIPPERS Adjusting INSTALLING/ADJUSTING ANTI-TIPPERS Figure2 to 2-inch ClearanceAnti-tipper Ground/FloorEngaging Tilt in SPACE/RECLINER Operation TILT/RECLINE ProcedureTILT/RECLINE Engaging TILT-IN-SPACE Figure Procedure TILT/RECLINETILT-IN-SPACE Tilt SlideGas Cylinder TILT/RECLINE Procedure Recliner Operation FigureCable Locking Nut Trigger Release Lever Cable Adjusting Nut Adjusting Tilt Trigger Release Cables FigureBearing Housing Adjusting Upper Tilt Locking Collar FigurePositioning Tilt Locking Collars Magnetic protractor reads desired angle of tiltReplacing the Headrest Upholstery Replacing the Back UpholsteryHeadrest Upholstery Extension Back Cane Back UpholsteryInch Seat Cushion Position Adjusting the Back Height Recliner Models only FigureProcedure Contracture Footplate Contracture Assembly Angle Adjustment FigureFootplatecontracture Mounting ScrewAngle Adjustment of the Contracture Footplate Figure Using the Optional Quick Release PIN FigureContracture Footplate Depth Adjustment Figure ContractureReplacing the Contracture Footplate Heel Loop Figure Contracture Footplate Height Adjustment FigureMounting Hole ContractureSolara jr Solara jr Warranty Limited WarrantyWarranty One Invacare Way

1106628 specifications

The Invacare 1106628 is a robust and innovative mobility solution designed to enhance the quality of life for individuals with limited mobility. This power wheelchair combines advanced technology and user-friendly features, making it an excellent choice for both indoor and outdoor use.

One of the standout characteristics of the Invacare 1106628 is its versatile seating system, which provides optimal comfort and support. The seat is designed to accommodate various body types and can be adjusted to ensure perfect alignment and positioning. Additionally, the chair includes a contoured backrest that offers lumbar support, promoting good posture during extended use.

Technology plays a significant role in the design of the Invacare 1106628. The wheelchair is equipped with a powerful motor and a durable battery system, allowing for a long driving range and reliable performance. With a top speed that makes navigating urban settings easy, users can enjoy both independence and accessibility. The advanced joystick control allows for smooth and precise maneuvering, enabling efficient navigation through tight spaces.

The wheelchair also boasts a sturdy construction, ensuring it can withstand the rigors of daily use. The frame is made from high-quality materials, providing durability while remaining lightweight enough for easy transport. Its compact design enhances maneuverability, making it suitable for use in various environments, from bustling shopping malls to narrow hallways in homes.

Safety features are paramount in the design of the Invacare 1106628. The wheelchair comes with anti-tip wheels, ensuring stability during movement, particularly when climbing slopes or navigating uneven terrain. The durable tires are designed for excellent traction, further enhancing safety and control in various outdoor settings.

In terms of additional features, the Invacare 1106628 includes customizable options such as adjustable armrests, footrests, and various accessory attachments. This flexibility allows users to tailor the wheelchair to their specific needs, enhancing overall comfort and usability.

In conclusion, the Invacare 1106628 is a well-engineered power wheelchair that incorporates advanced technology, safety features, and customizable options. It is designed to provide individuals with mobility challenges the independence and support they need, making it a valuable asset for users seeking to improve their quality of life. Whether navigating through their home or enjoying the great outdoors, the Invacare 1106628 delivers on performance, comfort, and durability.
Top Page Image Contents