EDGE Tech Edge 540 specifications ELEVATOR-RUDDER Pushrod Installation

Page 19

EDGE 540.

Instruction Manual.

2)Position the elevator horn on the both side of elevator. The clevis attach- ment holes should be positioned over the hinge line.

2mm x 20 mm.

Control Horn.

Mounting Screws.

Mounting Plate.

 

3)Using a 1.5mm drill bit and the control horns as a guide, drill the mounting holes through the elevator halves.

4)Mount the control horns by inserting the bolts through the control horn bases and elevator halves, then into the mounting backplates. Do not overtighten the nuts or the backplates may crush the wood.

5)Position the rudder control horn on the left side of the airplane. Mount the control horn parallel with the horizontal stabilizer.

6)Install the rudder control horn using the same method as with the elevator control horns.

Elevator control horn.

Elevator control horn.

Rudder control horn.

ELEVATOR-RUDDER PUSHROD

INSTALLATION.

Elevator - rudder pushrods assembly follow pictures below.

11.8cm.

Rudder pushrod.

Elevator pushrod.

10.8cm.

C/A glue.

Left side.

19

Image 19
Contents Edge Tools & Supplies Needed Parts ListingIntroduction Additional Items RequiredEdge Hinging the Ailerons Hinging the Elevators Hinging the Rudder Installing the Aileron Servos Aileron Linkage Servo arm Engine Mount Installing the BatteryFuel Tank Mounting the Engine Wheel and Wheel Pants Follow diagram below for wheel pant installation Cowling Installing the Main Landing GearInstalling the Spinner Horizontal Stabilizer Elevator Rudder Servo InstallationVertical Stabilizer Installation Control Horn Installation ELEVATOR-RUDDER Pushrod Installation Mounting the Tail Wheel Bracket Installing Tail Strut SystemMounting the Control Clasp Installing the Fuselage Servo Installing the SwitchThrottle Servo Installation Installing the Receiver Balancing Attachment WING-FUSELAGEControl Throws Preflight Check Flight PreparationEdge Edge