EDGE 540. | Instruction Manual. |
|
|
Right side.
MOUNTING THE TAIL WHEEL BRACKET.
1)Set the tail wheel assembly in place on the plywood plate. The pivot point of the tail wheel wire should be even with the rudder hinge line and the tail wheel bracket should be centered on the plywood plate.
2 Using a pen, mark the locations of the two mounting screws. Remove the tail wheel bracket and drill 1mm pilot holes at the loca- tions marked.
3)Secure the tail wheel bracket in place using two 3mm x 12mm wood screws. Be careful not to overtighten the screws.
MOUNTING THE CONTROL CLASP.
See pictures below:
2mm X 20mm.
Control clasp.
2 screws.
INSTALLING TAIL STRUT SYSTEM.
Tail strut system assembly follow pictures below.
3.2mm drill bit.
20