EDGE Tech Edge 540 specifications Elevator Rudder Servo Installation, Horizontal Stabilizer

Page 16

EDGE 540.

Instruction Manual.

 

 

ELEVATOR - RUDDER SERVO

INSTALLATION.

1)Locate and cut out the covering film from the servo holes in both sides of fuselage.

Remove covering.

2)Install the rubber grommets and brass collets onto the elevator and rudder servo. Test fit the servo into the aileron servo mount.

Because the size of servos differ, you may need to adjust the size of the precut opening in the mount. The notch in the sides of the mount allow the servo lead to pass through.

3)Secure the servos with the screws pro- vided with your radio system.

Left side.

Elevator servo.

Right side.

Elevator

Rudder servo.

servo.

HORIZONTAL STABILIZER.

1)Using a ruler and a pen, locate the centerline of the horizontal stabilizer, at the trail- ing edge, and place a mark. Use a triangle and extend this mark, from back to front, across the top of the stabilizer. Also extend this mark down the back of the trailing edge of the stabilizer.

16

Center line.

2)Using a modeling knife, carefully re- move the covering at mounting slot of horizon- tal stabilizer ( both side of fuselage).

Remove covering.

3)Slide the stabilizer into place in the pre- cut slot in the rear of the fuselage. The stabi- lizer should be pushed firmly against the front of the slot.

4)With the stabilizer held firmly in place, use a pen and draw lines onto the stabilizer where it and the fuselage sides meet. Do this on both the right and left sides and top and bottom of the stabilizer.

Pen.

5)Remove the stabilizer. Using the lines you just drew as a guide, carefully remove the covering from between them using a model- ing knife.

Image 16
Contents Edge Parts Listing IntroductionAdditional Items Required Tools & Supplies NeededEdge Hinging the Ailerons Hinging the Elevators Hinging the Rudder Installing the Aileron Servos Aileron Linkage Servo arm Engine Mount Installing the BatteryFuel Tank Mounting the Engine Wheel and Wheel Pants Follow diagram below for wheel pant installation Installing the Main Landing Gear CowlingInstalling the Spinner Elevator Rudder Servo Installation Horizontal StabilizerVertical Stabilizer Installation Control Horn Installation ELEVATOR-RUDDER Pushrod Installation Mounting the Tail Wheel Bracket Installing Tail Strut SystemMounting the Control Clasp Installing the Fuselage Servo Installing the SwitchThrottle Servo Installation Installing the Receiver Balancing Attachment WING-FUSELAGEControl Throws Flight Preparation Preflight CheckEdge Edge