EDGE 540. | Instruction Manual. |
1.5mm wire (needle valve).
3)Slide the cowl back over the engine and secure it in place using six 3mm x 10mm wood screws. See picture below.
4)Install the muffler and muffler extension onto the engine and make the cutout in the cowl for muffler clearance. Connect the fuel and pressure lines to the carburetor, muffler and fuel filler valve.
3mm X 10mm (6pcs).
INSTALLING THE SPINNER.
1)Install the spinner backplate, propeller and spinner cone. The spinner cone is held in place using two 3mm x 15mm wood screws. (spinner is not included).
The propeller should not touch any part of the spinner cone. If it does, use a sharp modeling knife and carefully trim away the spinner cone where the pro-
peller comes in contact with it.
15