EDGE Tech Edge 540 specifications Installing the Receiver

Page 22

EDGE 540.

Instruction Manual.

 

 

Adjustable Servo connector.

Servo arm.

2)Install the rubber grommets and brass collets onto the throttle servo. Test fit the servo into the aileron servo mount.

Because the size of servos differ, you may need to adjust the size of the precut opening in the mount. The notch in the sides of the mount allow the servo lead to pass through.

3)Secure the servos with the screws pro- vided with your radio system.

4) Install the pushrod throttle.

Throttle.

INSTALLING THE RECEIVER.

1)Plug the six servo leads and the switch lead into the receiver. Plug the battery pack lead into the switch also.

2)Wrap the receiver and battery pack in the protective foam rubber to protect them from vibration.

3)Route the antenna in the antenna tube inside the fuselage and secure it to the bot- tom of fuselage using a plastic tape. See pic- ture below.

22

Receiver.

Antenna tube.

Antenna.

Antenna.

Image 22
Contents Edge Additional Items Required Parts ListingIntroduction Tools & Supplies NeededEdge Hinging the Ailerons Hinging the Elevators Hinging the Rudder Installing the Aileron Servos Aileron Linkage Servo arm Engine Mount Installing the BatteryFuel Tank Mounting the Engine Wheel and Wheel Pants Follow diagram below for wheel pant installation Installing the Main Landing Gear CowlingInstalling the Spinner Elevator Rudder Servo Installation Horizontal StabilizerVertical Stabilizer Installation Control Horn Installation ELEVATOR-RUDDER Pushrod Installation Mounting the Tail Wheel Bracket Installing Tail Strut SystemMounting the Control Clasp Installing the Fuselage Servo Installing the SwitchThrottle Servo Installation Installing the Receiver Balancing Attachment WING-FUSELAGEControl Throws Flight Preparation Preflight CheckEdge Edge