EDGE Tech Edge 540 specifications Installing the Aileron Servos

Page 7

EDGE 540.

Instruction Manual.

C/A glue.

5)Turn the vertical fin panel over and deflect the rudder in the opposite direction from the opposite side. Apply thin C/A glue to each hinge, making sure that the C/A penetrates into the rudder and fuselage panel.

6)Using C/A remover/debonder and a paper towel, remove any excess C/A glue that may have accumulated on the fuselage or in the rudder hinge area.

Note:Work the rudder left and right several times to “work in” the hinges and check for proper movement.

Install the rubber grommets and brass collets onto the aileron servo. Test fit the servo into the aileron servo mount.

Install the servo into the servo tray.

Secure the servos with the screws pro- vided with your radio system.

Because the size of servos differ, you may need to adjust the size of the precut opening in the mount. The notch in the sides of the mount allow the servo lead to pass through.

Using a small weight (Weighted fuel pick-up works well) and thread, feed the string through the wing as indicated.

INSTALLING THE AILERON SERVOS.

Small weight.

Servo.Thread.

We recommended to use long servos arm for all servos without throttle servo.

Thread.

Small weight.

 

Wing bottom.

Thread.

 

 

Small weight.

Attach the string to the servo lead and carefully thread it though the wing. Once you have thread the lead throught the wing, remove the string so it can use for the other servo lead. Tape the servo lead to the wing to prevent it from falling back into the wing.

7

Image 7
Contents Edge Tools & Supplies Needed Parts ListingIntroduction Additional Items RequiredEdge Hinging the Ailerons Hinging the Elevators Hinging the Rudder Installing the Aileron Servos Aileron Linkage Servo arm Engine Mount Installing the BatteryFuel Tank Mounting the Engine Wheel and Wheel Pants Follow diagram below for wheel pant installation Cowling Installing the Main Landing GearInstalling the Spinner Horizontal Stabilizer Elevator Rudder Servo InstallationVertical Stabilizer Installation Control Horn Installation ELEVATOR-RUDDER Pushrod Installation Mounting the Tail Wheel Bracket Installing Tail Strut SystemMounting the Control Clasp Installing the Fuselage Servo Installing the SwitchThrottle Servo Installation Installing the Receiver Balancing Attachment WING-FUSELAGEControl Throws Preflight Check Flight PreparationEdge Edge