EDGE 540. | Instruction Manual. |
Servo arm. |
Straigh line. |
2) Locate the two nylon control horns, two nylon control horn backplates and two ma- chine screws.
2mm x 30 mm.
3)Position the aileron horn on the bottom side of aileron. The clevis attachment holes should be positioned over the hinge line.
Control Horn.
7)Pushrod assemble as same as pictures below:
Mounting Screws. | Mounting Plate. |
|
4)Using a 1mm drill bit and the control horns as a guide, drill the mounting holes through the aileron halves.
5) Mount the control horns by inserting the screws through the control horn bases and aileron halves, then into the mounting backplates. Do not overtighten the screws or the backplates may crush the wood.
6)Thread one nylon adjustable control horn onto each aileron control rod. Thread the horns on until they are flush with the ends of the control rods.
M3 lock nut.
Pushrod.
2.8cm.
9