EDGE Tech Edge 540 specifications Installing the Switch, Installing the Fuselage Servo

Page 21

EDGE 540.

Instruction Manual.

3x10mm.

INSTALLING THE SWITCH.

Install the switch into the precut hole in the servo tray, in the fuselage, from the bottom. Use the two screws provided with the switch to secure it in place. Drill two 3/32” holes through the tray for the screws to pass through.

3/ 32” Hole.

Switch.

INSTALLING THE FUSELAGE SERVO.

Throttle servo.

THROTTLE SERVO INSTALLATION.

1) Install adjustable servo connector in the servo arm.

21

Image 21
Contents Edge Introduction Parts ListingAdditional Items Required Tools & Supplies NeededEdge Hinging the Ailerons Hinging the Elevators Hinging the Rudder Installing the Aileron Servos Aileron Linkage Servo arm Installing the Battery Engine MountFuel Tank Mounting the Engine Wheel and Wheel Pants Follow diagram below for wheel pant installation Cowling Installing the Main Landing GearInstalling the Spinner Horizontal Stabilizer Elevator Rudder Servo InstallationVertical Stabilizer Installation Control Horn Installation ELEVATOR-RUDDER Pushrod Installation Installing Tail Strut System Mounting the Tail Wheel BracketMounting the Control Clasp Installing the Switch Installing the Fuselage ServoThrottle Servo Installation Installing the Receiver Attachment WING-FUSELAGE BalancingControl Throws Preflight Check Flight PreparationEdge Edge