Leica DM750 manual Instructions on use, Place of use, Fungus, Non-intended use

Page 10

Instructions on use

The Leica DM750 microscope may be used only in closed rooms and must be placed on a solid substrate.

The Leica DM750 microscope can be used in clean rooms without any problems.

Always position the Leica DM750 microscope so that you can disconnect it from the power supply at any time. The power

cable must remain accessible at all times, because it is intended as a power disconnect device.

Place of use

Only use the instruments in closed, dust free rooms and between +10°C and +40°C. Protect the devices from oil, chemicals and extreme humidity. If using the devices outdoors, protect them from dust and moisture. Never use electri- cal devices outdoors. Install electrical devices at least 10 cm from the wall and away from flam- mable substances.

Avoid large temperature fluctuations, direct sunlight and vibrations. These conditions can distort measurements and micrographic images.

In warm and warm-damp climatic zones, the individual components require special care in order to prevent the build-up of

fungus.

Non-intended use

Never install any other plug (NEMA 5-15P) or unscrew any mechanical components unless expressly instructed to do

so in the instructions.

The devices and accessories described in this instruction manual have been tested

for safety and potential hazards.

Leica DM750

Manual

10

 

 

 

Image 10
Contents Leica DM750 Manual Manufacturer information Responsible for contentsPublished in November 2010 by Chapter overview Contents Safety regulations Safety concept Provide clarity Light bulbsImportant information Explanatory notesDescription Safety instructionsImportant Notes Contact addressIntended Purpose of the Microscope Place of use So in the instructions For safety and potential hazardsInstructions on use FungusTransport Rights to any warranty claimsScope of this manual DisposalDual or detachable eyecups Health risks and dangers of useHealth risks LED Klasse 1 /LED 1 Laser ProductInformation for the person responsible for the instrument Information for the person responsible for the instrumentϘϘ Remove tough dirt using alcohol or petro- leum ether Cleaning coated parts and plastic partsCleaning glass surfaces Care instructionsMaintenance Accessories, maintenance and repairAccessories Repairs and service workElectrical data Fuse ReplacementElectrical data and ambient conditions EnvironmentLeica DM750 Introduction Result if used improperlyUnpacking Ready Leica DM750 is available with two Adjustable Condenser CenteringSubstage Illumination Types of Substage Illumination. Identify ToolTools used Attaching the viewing TubesϘϘ Allen key Leica EZ Viewing Tube integrated eyepieces Leica EZ viewing tube with integrated eyepiecesTightening the captive thumbscrew again Eyepieces Continue with the Eyecups section onInsert the eyepieces into the tubes Leica Standard Viewing Tube separated eyepiecesOrientation Eyecups Installing Objectives section onOrder to help block out ambient room light Installing Objectives Installing ObjectivesObjective nosepiece Ser needs to be installed Installing the Substage CondenserSubstage Condenser Thus roughly centered Set Turning on the microscope Power CordSetting the Illumination Intensity Work SurfaceDelivery package or, for a Leica DM750 Complete Condenser CenteringWith Koehler illumination, tighten Knurled screws Using the Condenser Using the CondenserPrepare to View a Specimen Slide Slide grips hold the slide in placeFocusing Standard Viewing Tube with One or Two Focusing Eyepieces Viewing Tube AdjustmentAdjust the eyetubes Leica EZ Viewing TubeOn and your adjustments will be minimal Koehler Configuration Condenser focusing knobKoehler Configuration Oil Immersion Technique Oil Immersion Technique Or Disabled and you will not see any blinking Time Delay ShutoffChanging the status of the time delay shutoff No changes in the intensity controlLeica DM750 Manual Ready! Set! Go Care of the Microscope Instructions for cleaning General maintenanceStorage and handling Mechanical Maintenance IlluminationTroubleshooting Troubleshooting Make sure that a DF objective is being usedPhase contrast Dimensions Leica DM750 Manual Leica DM750 Manual Leica DM750 Manual