Leica
DM750
manual
Ready
Troubleshooting
Install
Time Delay Shutoff
Warranty
Dimension
Maintenance
Koehler Configuration
Adjustable Condenser Centering
Phase contrast
Cleaning glass surfaces
Page 20
Ready!
Leica DM750
Manual
20
Page 19
Page 21
Image 20
Page 19
Page 21
Contents
Leica DM750 Manual
Published in November 2010 by
Responsible for contents
Manufacturer information
Chapter overview
Contents
Safety regulations
Safety concept
Light bulbs
Important information
Provide clarity
Explanatory notes
Safety instructions
Important Notes
Description
Contact address
Intended Purpose of the Microscope
So in the instructions For safety and potential hazards
Instructions on use
Place of use
Fungus
Rights to any warranty claims
Scope of this manual
Transport
Disposal
Health risks and dangers of use
Health risks
Dual or detachable eyecups
LED Klasse 1 /LED 1 Laser Product
Information for the person responsible for the instrument
Information for the person responsible for the instrument
Cleaning coated parts and plastic parts
Cleaning glass surfaces
ϘϘ Remove tough dirt using alcohol or petro- leum ether
Care instructions
Accessories, maintenance and repair
Accessories
Maintenance
Repairs and service work
Fuse Replacement
Electrical data and ambient conditions
Electrical data
Environment
Leica DM750
Introduction
Result if used improperly
Unpacking
Ready
Adjustable Condenser Centering
Substage Illumination
Leica DM750 is available with two
Types of Substage Illumination. Identify Tool
ϘϘ Allen key
Attaching the viewing Tubes
Tools used
Leica EZ Viewing Tube integrated eyepieces
Leica EZ viewing tube with integrated eyepieces
Tightening the captive thumbscrew again
Eyepieces Continue with the Eyecups section on
Orientation
Leica Standard Viewing Tube separated eyepieces
Insert the eyepieces into the tubes
Order to help block out ambient room light
Installing Objectives section on
Eyecups
Objective nosepiece
Installing Objectives
Installing Objectives
Substage Condenser
Installing the Substage Condenser
Ser needs to be installed
Thus roughly centered
Set
Power Cord
Setting the Illumination Intensity
Turning on the microscope
Work Surface
With Koehler illumination, tighten Knurled screws
Complete Condenser Centering
Delivery package or, for a Leica DM750
Using the Condenser
Using the Condenser
Prepare to View a Specimen Slide
Slide grips hold the slide in place
Focusing
Viewing Tube Adjustment
Adjust the eyetubes
Standard Viewing Tube with One or Two Focusing Eyepieces
Leica EZ Viewing Tube
On and your adjustments will be minimal
Koehler Configuration
Condenser focusing knob
Koehler Configuration
Oil Immersion Technique
Oil Immersion Technique
Time Delay Shutoff
Changing the status of the time delay shutoff
Or Disabled and you will not see any blinking
No changes in the intensity control
Leica DM750 Manual
Ready! Set! Go
Care of the Microscope
Storage and handling
General maintenance
Instructions for cleaning
Mechanical Maintenance
Illumination
Troubleshooting
Troubleshooting
Make sure that a DF objective is being used
Phase contrast
Dimensions
Leica DM750 Manual
Leica DM750 Manual
Leica DM750 Manual
Related pages
What are the maintenance steps for my Lopi wood stove?
Find out here
Top
Page
Image
Contents