Leica DM750 manual Installing the Substage Condenser, Ser needs to be installed

Page 28

Installing the Substage Condenser

Substage Condenser

The Leica DM750 has an open substage condenser mount, therefore the conden-

ser needs to be installed.

1.Move the specimen stage upwards as far as it will go by using the coarse focusing knob on the side of the microscope.

3.Unscrew the two setscrews (or wings- crews for Koehler stands) on the condenser holder.

	2. Move the condenser holder into the lowest
	position by using the condenser focusing
The substage condenser mount is open	knob on the left side of the stage mount.

Leica DM750	Manual	28

Image 28

Contents Leica DM750 Manual Manufacturer information Responsible for contentsPublished in November 2010 by Chapter overview Contents Safety regulations Safety concept Light bulbs Important informationProvide clarity Explanatory notesSafety instructions Important NotesDescription Contact addressIntended Purpose of the Microscope So in the instructions For safety and potential hazards Instructions on usePlace of use FungusRights to any warranty claims Scope of this manualTransport DisposalHealth risks and dangers of use Health risksDual or detachable eyecups LED Klasse 1 /LED 1 Laser ProductInformation for the person responsible for the instrument Information for the person responsible for the instrumentCleaning coated parts and plastic parts Cleaning glass surfacesϘϘ Remove tough dirt using alcohol or petro- leum ether Care instructionsAccessories, maintenance and repair AccessoriesMaintenance Repairs and service workFuse Replacement Electrical data and ambient conditionsElectrical data EnvironmentLeica DM750 Introduction Result if used improperlyUnpacking Ready Adjustable Condenser Centering Substage IlluminationLeica DM750 is available with two Types of Substage Illumination. Identify ToolTools used Attaching the viewing TubesϘϘ Allen key Leica EZ Viewing Tube integrated eyepieces Leica EZ viewing tube with integrated eyepiecesTightening the captive thumbscrew again Eyepieces Continue with the Eyecups section onInsert the eyepieces into the tubes Leica Standard Viewing Tube separated eyepiecesOrientation Eyecups Installing Objectives section onOrder to help block out ambient room light Installing Objectives Installing ObjectivesObjective nosepiece Ser needs to be installed Installing the Substage CondenserSubstage Condenser Thus roughly centered Set Power Cord Setting the Illumination IntensityTurning on the microscope Work SurfaceDelivery package or, for a Leica DM750 Complete Condenser CenteringWith Koehler illumination, tighten Knurled screws Using the Condenser Using the CondenserPrepare to View a Specimen Slide Slide grips hold the slide in placeFocusing Viewing Tube Adjustment Adjust the eyetubesStandard Viewing Tube with One or Two Focusing Eyepieces Leica EZ Viewing TubeOn and your adjustments will be minimal Koehler Configuration Condenser focusing knobKoehler Configuration Oil Immersion Technique Oil Immersion Technique Time Delay Shutoff Changing the status of the time delay shutoffOr Disabled and you will not see any blinking No changes in the intensity controlLeica DM750 Manual Ready! Set! Go Care of the Microscope Instructions for cleaning General maintenanceStorage and handling Mechanical Maintenance IlluminationTroubleshooting Troubleshooting Make sure that a DF objective is being usedPhase contrast Dimensions Leica DM750 Manual Leica DM750 Manual Leica DM750 Manual