Leica
manual
Leica DM750 Manual
Troubleshooting
Install
Time Delay Shutoff
Warranty
Dimension
Maintenance
Koehler Configuration
Adjustable Condenser Centering
Phase contrast
Cleaning glass surfaces
Page 54
Leica DM750
Manual
54
Page 53
Page 54
Image 54
Page 53
Page 54
Contents
Leica DM750 Manual
Responsible for contents
Manufacturer information
Published in November 2010 by
Chapter overview
Contents
Safety regulations
Safety concept
Provide clarity
Light bulbs
Important information
Explanatory notes
Description
Safety instructions
Important Notes
Contact address
Intended Purpose of the Microscope
Place of use
So in the instructions For safety and potential hazards
Instructions on use
Fungus
Transport
Rights to any warranty claims
Scope of this manual
Disposal
Dual or detachable eyecups
Health risks and dangers of use
Health risks
LED Klasse 1 /LED 1 Laser Product
Information for the person responsible for the instrument
Information for the person responsible for the instrument
ϘϘ Remove tough dirt using alcohol or petro- leum ether
Cleaning coated parts and plastic parts
Cleaning glass surfaces
Care instructions
Maintenance
Accessories, maintenance and repair
Accessories
Repairs and service work
Electrical data
Fuse Replacement
Electrical data and ambient conditions
Environment
Leica DM750
Introduction
Result if used improperly
Unpacking
Ready
Leica DM750 is available with two
Adjustable Condenser Centering
Substage Illumination
Types of Substage Illumination. Identify Tool
Attaching the viewing Tubes
Tools used
ϘϘ Allen key
Leica EZ Viewing Tube integrated eyepieces
Leica EZ viewing tube with integrated eyepieces
Tightening the captive thumbscrew again
Eyepieces Continue with the Eyecups section on
Leica Standard Viewing Tube separated eyepieces
Insert the eyepieces into the tubes
Orientation
Installing Objectives section on
Eyecups
Order to help block out ambient room light
Installing Objectives
Installing Objectives
Objective nosepiece
Installing the Substage Condenser
Ser needs to be installed
Substage Condenser
Thus roughly centered
Set
Turning on the microscope
Power Cord
Setting the Illumination Intensity
Work Surface
Complete Condenser Centering
Delivery package or, for a Leica DM750
With Koehler illumination, tighten Knurled screws
Using the Condenser
Using the Condenser
Prepare to View a Specimen Slide
Slide grips hold the slide in place
Focusing
Standard Viewing Tube with One or Two Focusing Eyepieces
Viewing Tube Adjustment
Adjust the eyetubes
Leica EZ Viewing Tube
On and your adjustments will be minimal
Koehler Configuration
Condenser focusing knob
Koehler Configuration
Oil Immersion Technique
Oil Immersion Technique
Or Disabled and you will not see any blinking
Time Delay Shutoff
Changing the status of the time delay shutoff
No changes in the intensity control
Leica DM750 Manual
Ready! Set! Go
Care of the Microscope
General maintenance
Instructions for cleaning
Storage and handling
Mechanical Maintenance
Illumination
Troubleshooting
Troubleshooting
Make sure that a DF objective is being used
Phase contrast
Dimensions
Leica DM750 Manual
Leica DM750 Manual
Leica DM750 Manual
Top
Page
Image
Contents
