Grandstream Networks GXP2100, GXP2110, GXP1450 user manual Firmware Version

Call-Waiting Tone

Busy Tone

Reorder Tone

Intercom User ID

Disable Call-Waiting

Disable Call-Waiting Tone

Disable Direct IP Calls

Use Quick IP-Call mode

Disable Conference

Enable MPK sending DTMF

Disable DND Button

Disable Transfer

Auto-Attended Transfer

In-call dial number on pressing transfer key

Configuration via Keypad Menu

Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]]; (Frequencies are in Hz and cadence on and off are in 10ms)

ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of silence. In order to set a continuous ring, OFF should be zero. Otherwise it will ring ON ms and a pause of OFF ms and then repeat the pattern. Up to three cadences are supported.

Configures the intercom extension number for account 1 to dial out (Not applicable to GXP1450). This User ID is mapped to the INTERCOM button on the phone.

Disables the call waiting feature. The default setting is "No".

Disables the call waiting tone when call waiting is on. The default setting is "No".

Disables Direct IP Call. The default setting is "No".

When set to "Yes", users can dial an IP address under the same LAN/VPN segment by entering the last octet in the IP address. To dial quick IP call, off hook the phone and dial #XXX (X is 0-9 and XXX <=255), phone will make direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet mask. #XX or #X are also valid so leading 0 is not required (but OK). No SIP server is required to make quick IP call. The default setting is "No".

Disables the Conference function. The default setting is "No".

Enables Multi Purpose Key to send DTMF during the call (Not applicable to GXP1450). The default setting is "No".

If set to "Yes", the DND button will not set the phone to DND. The default setting is "No".

Disables the Transfer function. The default setting is "No".

If set to "Yes", the phone will use attended transfer by default. The default setting is "No".

Configures the number for the phone to dial as DTMF during the call using TRAN button.

Configures the access control for the users to configure from keypad Menu. There are three different options:

•Unrestricted. All the options can be accessed in keypad Menu.

•Basic settings only. The CONFIG option will not display for users to access in keypad Menu.

•Constraint Mode. CONFIG, FACTORY FUNCTIONS and

FIRMWARE VERSION 1.0.4.23 GXP2120/GXP2110/GXP2100/GXP1450 USER MANUAL Page 59 of 69