answer calls, it will answer after about ten rings and sound a series of beeps.
2.When the outgoing message begins (or the system sounds a series of beeps), press #. Then enter your security code within 2 seconds.
3.If the code is correct, the system announces the number of new and old messages, and then “To play incoming message, press# 2. For help, press # 0." If the system does not respond, try entering your code again. If you enter an incorrect code three times, the system beeps and disconnects.
4.While the system is beeping, press # and (within 2 seconds) the number for the desired command.
Press # then | To |
|
|
Repeat current message during playback. If you press # 1 within about
14 seconds after a message begins, the previous message replays (unless it is the first new message).
Play messages. The remote playback for incoming messages is limited to 4
2minutes. If you have more messages, you must press # 2 again to listen to the rest of the messages.
3Skip current message during playback. Delete current message during
4 | playback. You can only delete the | |
current message, you cannot delete all | ||
| ||
| the stored messages. |
5Stop playback or recording. Set the system to answer calls.
6Announces the current outgoing message.
Remote Operation
43