52 | Using the RAV — Using the Controller |
Using the Controller
Managing Calls
Most phone specific functions, such as dialing a call or adding a phonebook entry, will be managed from the RF controller. Phonebook and dialer actions can be done through Rav- Ware as well. See page 43 for more information.
| Using the RAV — Using the Controller |
| 53 |
| |
| To use speed dial | Note: You can dial numbers |
| ||
| • Press and hold the assigned speed dial | pressing and holding the assigned number. |
| ||
| To dial speed dial 10, press and hold 0. |
| |||
| number on the dial pad. |
| |||
|
|
|
|
| |
|
|
|
|
| |
| To redial a phone number | Note: REDIAL saves the last number that |
| ||
|
| was dialed from the controller. Once |
| ||
|
| REDIAL is pressed, the phone will be taken |
|
To answer a call
Note: RAV can also be set to automatically answer calls. See page 56 to
• Press | . |
|
•Press on the RF controller to answer the call. When there is an incoming call, the phone rings and the LEDs on the microphones flash.
enable
To dial a call from the Phonebook
1.Press on the RF Controller.
2.Scroll to the entry and press .
Conference * Product Management
To make a call
Sales Team
1. | Press | . You will hear a dial tone. |
2. | Dial the number as you would on a |
Figure 4.2. Dialing from the phonebook
standard phone.The number appears on |
the LCD screen. |
Note: The controller accepts a maximum of 44 characters. No more than 44 characters can be entered.
18005781234
Figure 4.1. LCD screen
To use the status key
•Press and hold for two seconds to display the status of the RAV.
If the phone is not in use
ClearOne 55 10/13/04 14:33 PM 8013568518
Figure 4.3. On-hook status
To pre-dial a call
1.Dial a phone number.
You can press to delete the last digit entered in the
2.Press to send the call.
Note: The phonebook key will delete the entire dial string if you press it for two seconds. Pressing and holding the pound
(#)key for two seconds will insert a pause into the dialing string. The duration of the pause is two seconds.
If the phone is in use
11:14
10/13/04 14:33 PM 9795311468
To end a call | Note: RAV can also be set to | |
|
| automatically disconnect calls. See page |
• Press | to disconnect the call. | 57 to enable |
|
|
| Figure 4.4. |
|
| |
To send a flash signal | Note: This feature is dependent on your | |
|
| PBX service or local phone service. Refer |
• Press | to use call transfer, call waiting | to your PBX vendor or local telephone |
or conference calling. | service for details. | |
|
To mute/unmute microphones
1.Press to mute the microphones.The microphone LEDS will illuminate red.
2.Press again to unmute microphones. The microphone LEDS will illuminate green.
Note:This function mutes all microphones in the room.The microphone LEDs and the mixer front panel LEDs light red when the microphones are muted.
To adjust the speaker volume | Note: If an external amplifier is dragged | ||||
|
|
| to the line | output or record devices in | |
• Press |
| to increase the volume. | the volume buttons will be | ||
– Or – |
|
| programmed to | adjust the external | |
|
| amplifier. | See | page 37 for more | |
Press |
| to decrease the volume. | |||
| |||||
| information. |
| |||
|
|
|
|
Technical Services Group ~ | Technical Services Group ~ |