10 | Introduction — Installation Overview |
System Requirements for RAV-Ware
Component | Requirement |
|
| Windows 98 SE | 64 MB RAM |
Operating System and RAM | Windows 2000 | 256 MB RAM |
| Windows XP | 256 MB RAM |
|
| |
Processor | 300 MHz Pentium III or better | |
|
| |
Monitor | 1024 x 768 SVGA (16 bit) high color | |
|
| |
Video Card | SVGA 1024 x 768 minimum | |
|
|
|
Free Hard Disk Space | 20 MB minimum |
|
|
| |
Up to 115,200 baud rate | ||
|
|
|
USB port | USB |
|
|
| |
Flash Support | Macromedia Flash Player 6.0 | |
|
|
|
Note: Using a USB to serial adapter is not recommended.
Network Information
To use RAV over a local area network (LAN), you need to know if the LAN uses Dynamic Host Configuration Protocol (DHCP) or if you need a static IP address.
If the LAN uses DHCP, there is no need to make any network adjustments unless you want to assign a static IP address.
If the LAN does not use DHCP, gather the following information prior to LAN setup:
•The IP address to be assigned to the RAV
•The subnet mask
•The IP address of the default gateway
11
Technical Services Group ~ | Technical Services Group ~ |