ClearOne comm 600 Microphone Pods, Basic Room Design for RAV, Speakers ceiling- or wall-mount

6 Introduction — Product Overview

Microphone Pods

A

B

Figure 1.4. Microphone pods

A.Mute Button. Press to mute or unmute all microphones in the RAV system.

B.LEDs.These two LEDs illuminate green when the microphones are not muted and illuminate red when the microphone is muted.The LEDs flash red if the microphones are not connected properly.

Introduction— Basic Room Design 7

Basic Room Design

Basic Room Design for RAV

To ensure best microphone and loudspeaker placement (ceiling- or wall-mount), please use the following guidelines. For more information on Room Design, or to view the RAV online training course, visit www.clearone.com.

Microphones

Center mic pods on the table at an equal distance apart. Place the controller on the same table as the mics. In typical conferencing environments, participants should be seated 4–8' from a mic pod.

Mic pick-up range is dependent on room conditions. Background noise, reflective hard surfaces and the number of participants may affect the pick-up range. Use the following guidelines for best placement of your RAV mic pods and then adjust for your specific room conditions.

A

Figure 1.5. Speakers

Speakers (ceiling- or wall-mount)

A.Push Terminal connectors. Connect to the RAV mixer using speaker wire (wall-mount speakers are pictured).

RAV 900

4'

4'

Figure 1.6. Recommended microphone placement

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760 Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760