Telex C-2002 technical manual Line 1 level adjust, Ln1 Min Rx lvl -60dB, 60dB dwn Back, = -10dB

16 Vega’s C-2002

7.3.1Menu 1 - Line Level Settings

This screen is displayed after a line has been selected from the Level Menu Screen. The selected line number is shown on the display and the select LED for that line continues to blink. In this example Line 1 has been selected.

PROG1 - Go to RX Input Level Screen. PROG2 - Go to LAM level setup. PROG3 - Go to Line Levels Screen. PROG4 - Return to Level Menu Screen.

7.3.1.1 RX Input Level Screen

Line 1 level adjust

RX	LAM	back
PROG1	PROG2	PROG3 PROG4

The RX input levels serve as a master level adjustment allowing small adjustments in gain. This is a per line
adjustment. Typically these are left at 0 dB.
	Ln1 Min Rx lvl -60dB
PROG1 - Resets level setting to default of -60dB.	-60dB dwn	up	back
PROG2 - Increments the level setting by 1 dBm (max of 0dB).
	PROG1 PROG2	PROG3	PROG4
PROG3 - Decrements the level setting by 1 dBm (min of -60dB).
PROG4 - Return to Other Line Level Screen.

7.3.1.2 LAM Programming Screen

This screen shows the current settings for the Line Activity Monitor for the line number shown. The -U or -S after the channel number denotes whether the settings are for Select or Unselect Audio. Pressing PROG1 or PROG2 will modify the settings for the Select or Unselect characteristics displayed when the button is pressed.

PROG1 - go to LAM Duration After Release screen. PROG2 - go to LAM Trigger Level Screen. PROG3 - Toggle Select or Unselect LAM control. PROG4 - Return to Other Line Level Screen.

7.3.1.2.1 LAM Duration After Release screen

LAM1-S 7sec -10dBm dur lvl S/U back

PROG1 PROG2 PROG3 PROG4

This parameter determines how long the LAM light will flash after the triggering signal disappears.

PROG1 - Resets duration setting to default of 7 seconds.

PROG2 - Increments the time setting by 1 second (maximum of 25sec). PROG3 - Decrements the time setting by 1 second (minimum of 0sec). PROG4 - Saves the current duration setting and returns to the LAM

Programming Screen.

7.3.1.2.2 LAM Trigger Level Screen

LAM1-S Duration 7se 7sec dwn up back

PROG1 PROG2 PROG3 PROG4

These parameters determine the audio level required to trigger the LAM function.

PROG1 - Adjusts level at which the LAM triggers.

PROG2 - Increments the level setting by 1 dBm (max of 0dBm). PROG3 - Decrements the level setting by 1 dBm (min of -30dBm). PROG4 - Saves the current level setting and returns to the LAM

Programming Screen.

LAM1-U Level -10dB -10dB dwn up back

PROG1 PROG2 PROG3 PROG4

7.3.1.3 Mute Button Level Screen

These parameters are used to set the level of Mute on a Per line bases.

PROG1 – Sets level of mute to off (total quite).

PROG3 – Go to Edit level screen.

PROG4 - Return to Level Menu Screen.

Mute1 Level	= -10dB
OFF	edit back
PROG1 PROG2	PROG3 PROG4