Telex C-2002 System Settings PIN Txdel next back, PIN Setup New, New PIN, Enter PIN, Invalid PIN

Remote Control Console 23

7.4.4Menu 3 System Setup Screen

PROG1 - setup the console PIN number.

PROG2 - setup the Tx delay time.

PROG3 - Next Menu.

PROG4 - Returns to the System Setup Menu.

7.4.4.1 PIN Number Entry

Entering a PIN number, will cause the C-2002, when entering tech mode, to prompt for the PIN number. If the correct PIN number is entered tech mode is entered. If it is not, operating mode is resumed. This will keep unauthorized modifications from occurring.

PROG1 - Begin accepting new PIN.

PROG2 - Clear existing PIN such that none is required. PROG4 - Return to Menu 3.

Pressing New will change the screen to prompt for a PIN number to be entered. Only the Buttons 0-9 and A-D are valid for this operation. The PIN is a 4 digit code. ‘*’ will be echoed for each keystroke. Entry ends immediately upon the entry of the fourth digit. Once the PIN has been entered the first time, the system will prompt for it to be re- entered to verify proper entry. If the first and second PIN entries match, the user will be returned to the PIN Setup screen. If the entries do not match an error will be put on the screen and the PIN number will be cleared.

7.4.4.2 TX Delay Setup

System Settings

PIN Txdel next back

PROG1 PROG2 PROG3 PROG4

PIN Setup [----]

New	Clear	back
PROG1	PROG2	PROG3 PROG4

New PIN:**

PROG1 PROG2 PROG3 PROG4

Enter PIN:***

PROG1 PROG2 PROG3 PROG4

-- Invalid PIN --

OK

PROG1 PROG2 PROG3 PROG4

The C-2002 has the ability to delay transmit audio by up to 1 second. This allows an operator to begin speaking as soon as the microphone is keyed up. The radio system will have certain delays built in that under normal circumstances would not allow speech to be transmitted for a short period of time. By turning on this delay, this limitation is overcome.

PROG1 - Set the delay to 0 seconds (off).	TX Delay: 300msec
PROG2 - Decrease the delay by 0.1 seconds.	0s	dwn	up	back
PROG3 - Increase the delay by 0.1 seconds.	PROG1	PROG2	PROG3	PROG4
PROG4 - Returns to Menu 4 and saves the current delay.

7.4.5Menu 4 System Setup Screen

PROG1 - setup the Unselect function.

PROG2 - setup the Duplex function.

PROG3 - Next Menu (Menu 1).

PROG4 - Returns to the System Setup Menu.

7.4.5.1 Unselect Audio Mute

This option is used to Mute all Unselect audio during a PTT operation.

PROG1 - Changes the option between Enabled and Disabled. PROG3 - Moves to the first menu for Unselect audio setup. PROG4 - Return to top level menus.

System Settings Unsel Duplx nxt back

PROG1 PROG2 PROG3 PROG4

Unsel Mute w/PTT:OFF

Tglback

PROG1 PROG2 PROG3 PROG4