Telex C-2002 technical manual Mute Button

PROG3 PROG4

Line 1: Unsel Locked

Tgl next back

Remote Control Console 27

PROG1 - Toggles TXmon on and off.

PROG3 - Move to the next menu.

PROG4 - Saves the setting and returns to the Line Level screen.

7.6.6Automatic Gain Control (AGC) Enable/Disable

The Line Automatic Gain Control helps to equalize receive audio for all incoming levels.

PROG1 - Toggles AGC on and off. PROG3 - Move to the next menu.

PROG4 - Saves the setting and returns to the Line Level screen.

Line 1: AGC ON

Tgl	next back
PROG1 PROG2	PROG3 PROG4

7.6.7TX Enable/Disable per Line

TX can be enabled and disabled on a per line basis. This allows some lines to be setup that can be used for monitoring purposes only, but cannot be selected for transmission.

PROG1 - Toggles TX between Enabled and Disabled. PROG3 - Move to the next menu.

PROG4 - Saves the setting and returns to the Line Level screen.

7.6.8Forced Unselect of a Line

Line 1: TX Enabled

Tgl	next back
PROG1 PROG2	PROG3 PROG4

This option is used to lock a channel into a monitor mode. Once locked, the console operator can select the channel for transmission but mute will be disabled.mute the line.

PROG1 - Toggles Unselect between Normal and Locked. PROG3 - Move to the next menu.

PROG4 - Saves the setting and returns to the Line Level screen

7.6.9 DTMF ANI Decode Enable

Line 1: Unsel Locked

Tgl	next back
PROG1 PROG2	PROG3 PROG4

This option is used to enable DTMF ANI Decode. This function is used in conjunction with the DSP223 tone adapter and the Kenwood TK-x150 mobile radio. The Fleetsync ANI is sent down the line to the C-2002 in DTMF format. The DTMF ANI is decoded and displayed. For more

information, refer to the DSP-223 Technical Manual, Telex Communications Part Number 803274 Rev D or higher. Also, refer

to application note “DSP-223 Tone Remote Panel to Kenwood Series PROG1 PROG2 TK-x150/x180 Adaptor Kit” (PN 804136). Both items can be found

on the Vega website and the Vega Literature CD. PROG1 - Toggles DTMF ANI Decode.

PROG3 - Move to the next menu.

PROG4 - Saves the setting and returns to the Line Level screen

7.7 Mute Button

The mute button has two separate modes of operation. One is the Latched mode where monitored audio is muted until its toggled again. The second mode is the timed mute function in which the monitored audio is muted for a preset amount of time. Note: Mute button programming is per line and that the mute button can be pressed a second time during a timed mute to end the mute function prematurely.

	MUTE2 = 1 seconds
7.7.1 Per line Mute button Setup	Latch edit next back
PROG1 - Sets the Mute function to Timed or Latch mode.	PROG1	PROG2	PROG3	PROG4
PROG2 - Allows the duration of the mute function to be changed.
PROG3 - Move to the next menu.	MUTE1 = Latched
PROG4 - Return to top level menu.
	Timed		next back
	PROG1	PROG2	PROG3	PROG4