TMC ET4000 manual Additional Information FCC Information

Page 86

Additional Information

FCC Information

This equipment complies with Part 68 of the FCC rules. On the base of this equipment is a label that contains, among other information, the FCC registration number and ringer equivalence num- ber (REN) for this equipment. If requested, this information must be provided to the telephone company.

The FCC requires that you connect your telephone to the telephone network through a modular telephone outlet or jack, which must comply with FCC part 68 rules.The modular telephone outlet or jack to which your EPIC telephone must be connected is a USOC RJ11C or RJ14C.

The Facility Interface Codes (FIC) for your EPIC telephone is 02LS2 which is a 2-wire, Local Switched Access, Loop-start.

The REN is used to determine the quantity of devices which may be connected to the telephone line. The REN for your EPIC telephone is 0.2. Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of the RENs should not exceed five (5). To be certain of the number of devices that may be con- nected to the line, as determined by the total RENs, contact the telephone company to determine the maximum REN for the calling area.

If the terminal equipment EPIC telephone causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice isn’t practical, the telephone company will notify you as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.

The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens, the telephone company will pro- vide advance notice in order for you to make the necessary modifications in order to maintain unin- terrupted service.

If trouble is experienced with your EPIC telephone, please contact TMC Corporation at 1-800-TMC-1638for repair and/or warranty information. If the trouble is causing harm to the telephone network, the telephone company may request you remove the equipment from the network until the problem is resolved. Do not attempt to repair or modify this equipment. Please contact TMC Corporation for information on obtaining service for this product.

This equipment cannot be used on public coin service provided by the telephone company. Connection to Party Line Service is subject to state tariffs. (Contact the state public utility com- mission, public service commission or corporation commission for information.)

This equipment is hearing-aid compatible.

76

Page 85 Page 87
Image 86
Page 85 Page 87
Contents Please read before using telephone User’s GuideImportant Safety Instructions Getting StartedPacking List Before you beginExternal Paging Adapter Other Optional AccessoriesMusic On Hold Adapter Door Intercom/Door Opener AdapterTable of Contents Memory Dialing Index Expanding the Epic SystemAdditional Information LOW Battery Location of ControlsViii Installing Your System Identify Your Existing Wiring System If you have difficulty in identifying wall jacks If you are installing new wiring and jacksLabel the jacks at each location Installing Your System Plan Your Installation Standard InstallationInstallation Worksheet StnConnect Second Line Cord Installing Your System Install Desk/Table Top PhonesConnect First Line Cord Verify Proper Installation Connect Power CordInstall a 9-Volt Battery Optional Connect HandsetConnect Cords to Wall Installing Your System Install Wall Mounted PhonesConnect Cords to Telephone Reverse Handset HookAttach Telephone to Wall Using Station Names Installing Your System Verifying Proper Installation Setting Up Your System Setting Up Your System At a Glance Following must be done at each stationFollowing must be done at Station #11 Setting Up Your System Setting Automatic Line Selection To choose which line will be automatically selectedSetting Up Your System Setting Distinctive Ringing To assign distinctive rings to one or more linesSetting Up Your System Setting Up Toll Restriction Turning toll restriction on/off at a particular telephoneTo set the restricted numbers at a particular telephone WorksheetTo completely restrict specific lines at a telephone L1 RestrictedTo set the allowed numbers at a particular telephone EnterSetting Up Your System Setting System Call Privacy On/Off To set system call privacy on/off At Station #11To program L2 UnconnectedPage Intercom Indicator Operating Your System Indicator Light DescriptionLine indicators LCD Station In-Use IndicatorsOperating Your System To choose how each line will ringOperating Your System Adjusting Volume Levels Operating Your System Making a Tone/Pulse Selection To set your system to Tone or Pulse Dialing At Station #11Operating Your System Making and Answering a Call To make and answer calls using the handsetTo make and answer calls using the speakerphone To redial any of the last five phone numbers you dialed Operating Your System Using RedialTo redial the last phone num- ber you dialed Operating Your System Using Hold To put an outside call on holdTo answer a call ringing on another line To switch between linesTo make a call on another line To conference another station while on an outside call Operating Your System Conferencing CallsTo conference two outside calls Press Transfer To send a call to Another station To use the transfer ring To use one of eight personal ringsTo use call waiting caller ID Operating Your System Using Caller IDTo see the caller ID informa- tion of an incoming call To use the NEW Call LampEntering Area Codes into your Epic telephone To dial a number in the caller listTo delete numbers from the caller list To use your NEW Call lamp to indicate voice mail messages Operating Your System Using Telephone Company Voice MailTo access your voice mail mes- sages To turn off the NEW Call lampOperating Your System Using Flash Operating Your System Using Mute To turn mute on/off during a callOperating Your System To reserve a line that is cur- rently being used Operating Your System Using Line ReserveTo cancel Line Reserve Operating Your System Releasing Call Privacy To release call privacy during a callOperating Your System Using Toll Restriction To view the elapsed time dur- ing your call Operating Your System Using the Call TimerTo restart the timer from zero To view the length of your pre- vious five callsTo make and answer a call using the headset Page Memory Dialing Memory Features Directory CardTo dial a memory dial number Memory Dialing Using Memory DialTo store a memory dial num- ber To dial a personal directory number Memory Dialing Using Personal Directory DialTo store a personal directory dial number To dial a shared directory number Memory Dialing Using Shared Directory DialTo store a shared directory dial number At Station #11 Storing a hyphen into memory Memory Dialing Special Memory FeaturesStoring a switchhook flash into memory Storing a dialing pause into memoryPredialing Storing one of the last five numbers dialed into memoryStoring a Caller ID number into memory Erasing numbers stored in memoryIntercom Operation Making Intercom Calls To intercom another stationIf your phone is set to Intercom Voice Intercom Operation Answering Intercom CallsIf your phone is set to Intercom Ring If your phone is set to Intercom HandsfreeTo make an All Intercom Operation Making PagesTo page another station Blocking Pages at your telephone Intercom Operation Answering PagesTo answer a page directed to your station or an All To choose how your phone will respond to intercom calls To respond to an off hook voice announcement Intercom Operation Using Off Hook Voice AnnounceTo make an off hook voice announcement Blocking off hook voice announcements at your telephoneIntercom Operation Monitoring a Room Using the Intercom To the room you are monitoringGuide for Entering Names Intercom Operation Naming StationsTo Name a Station in Your Epic System At Station #11 Private Lines Standard ConfigurationExpanding the Epic System Important Note Auxiliary LinesTo assign a distinctive ring to your Centrex line Centrex Operation Using Centrex With Your Epic TelephoneTo set up a private Centrex line at your telephone To store a Centrex code into a memory locationCentrex Operation Storing the Centrex Prefix To store the Centrex prefixTo set up a telephone as a Centrex console Choices are Centrex CSL OFF factory setting Centrex CSL onTo set up a telephone to ring a Centrex console Using fax machines and computer modems Using other Epic intercom telephonesUsing standard telephones Additional Information Using the Data/Fax Jack To connect a modem or a fax machine to your Epic phoneExternal Feature Module set as a Music On Hold Adapter External Feature Module set as an External Paging AdapterTo unlock a magnetic door lock To adjust the door intercom bell volume at your telephoneTo answer a door speaker over the intercom Additional Information Replacing Your Battery Operation During a Power FailureAdditional Information Adjusting Held Call Reminder Additional Information Adjusting Auto Hold Drop Time Additional Information Adjusting Flash Length Additional Information Erasing All Feature Settings To erase all feature settings at a particular telephoneAdditional Information Setting the Loop Voltage Detector To set your telephone’s loop voltage detectorAdditional Information Troubleshooting Guide Controlled by a wall switchProblem Solution Additional Information FCC Information Automatic Dialers How do you make a warranty claim? Additional Information Warranty InformationWhat does your warranty cover? For how long after the original purchase?Limitations and Exclusions Index Dial, 32-33,46-47Index LIB702YY
Top Page Image Contents