VTech VT 1962 manual LCD Display Messages

Page 16

THE LCD DISPLAY

LCD Display Messages

the PHONE ON indicator is displayed when the phone is in use.

shows the Handset volume setting.

is displayed when the unit is in a low- battery condition. The Handset typically operates for at least 5 minutes after the low battery indication first appears.

is displayed when the Base Unit pages the Handset.

is displayed when the Handset is on hold.

is displayed when the Handset microphone has been muted.

is displayed when the Handset ringer has been programmed off.

is displayed when the Handset has lost communication with the Base Unit and is attempting to reestablish a link by scanning all channels.

is displayed if communication with the Base is reestablished.

is displayed while in OFF mode, if another phone is currently using the same line.

16

Image 16
Contents Introduction Special Features MHz OperationParts Check List FCC and IC Regulations FCC PartIC Industry Canada This telephone is registered for use in CanadaFCC and IC Regulations Important Safety Instructions Read and understand all instructionsIf the product exhibits a distinct change in performance Replacing the Battery Pack Charging The Handset Battery PackTo Charge The Battery Pack Its Impossible To Over-Charge The Battery PackReplace the battery case cover by sliding the cover upwards Spare Battery Charger InstallationPower Backup Replacing a Drained Handset batteryRbrctm Seal The Rbrcr Seal on the nickel-cadmium battery Setting Up Your VT AC Power AdapterSetting the Tone/Pulse Switch Getting StartedConnect Telephone Line Cord Using The Wall Mount Adapter Wall MountingLCD Display LCD Display MessagesHandset Features Handset LayoutBase Unit Features Base Unit LayoutQuick Reference Guide Using Redial Memory Dialing Speed DialingCID Caller ID To exit press OFFBasic Operation Switching calls using Flash Advanced FunctionsCall Waiting Temporary ToneChanging Ringer Types Turning Off The RingerChecking The Ringer Type To turn off the ringer do the followingCLR/DEL Key Function Advanced DialingMemory Dialing Dialing From MemoryIf programming is unsuccessful the unit will display Press Phone to get a lineDeleting Stored Numbers Changing Stored NumbersStoring Special Codes CID-CALLER ID Call Waiting Caller ID Type II CIDWord About Caller ID CID Receiving and Storing CallsTransmission Error Special Message Indicators Out of Area CallsPrivate Calls Reviewing Numbers Reviewing CID RecordsDeleting Numbers Answering System Setup Default Answering System SettingsAnswering System Program- ming Overview Set Outgoing Message OGMSecurity code default setting is Day and TimeSet Audible Message Alert Set Announce OnlySet Number of Rings Set Base Ringer On/OffBase ringer can be turned on or OFF Answering System Operations Leaving a Message Incoming MessageListening to Messages / Memos Saving MessagesDeleting Messages Turning the Answering MachineChanging Speaker Volume Call ScreeningCheck Current Day and Time Changing Playback SpeedMemory Full Power Failure Flashing number LED displays What it meansYou have no new messages Remote Operation of Answering System Playing Messages RemotelyRepeat Messages During Playback Skip Messages During PlaybackStop Message Playback Memo RecordingExiting Remote Operation Additional Operating Tips Operation Headset OperationBelt Clip Maintenance Handset Does Not Ring When You Receive a Call You Hear Other Calls While Using Your PhoneCase of Difficulty Phone Doesnt Work At AllCommon Cure For Electronic Equipment Warranty Statement Any defect in material or workmanshipTo the original purchaser only ONE Year At our option, repair or replace your unitWhat does OUR Warranty not COVER? Crystal Controlled Dual PLL Synthesizer Technical SpecificationsHandset 295 grams Base 470 grams Table of Contents Issue