Function Keys
Longhand Programming
1.Press 
Admin or 
Admin 1. See Display Key Programming. .
2.Pressing Expl? 
to switch to longhand programming mode.
3.Press Next 
until the required function required is shown, then press Selct 
.
4.If the function requires some data to be entered, [ is shown at the bottom of the display. Enter the data using the normal telephone keypad.
5.The upper part of the display reverts to showing the functions currently assigned to each 
and 
key.
6.Use the 
and 
keys to move between the pages of display keys.
7.Select the display key against which to program the new function by pressing that 
or 
key. Caution: Do not select the slot used for the Admin function. Replacing this function will lock the phone for further programming until reset through the telephone system.
8.If the display slot is not already used, the display shows BUTTON PROGRAMMED!.
•Press 
EXIT to end programming.
•Press 
Cont to continue programming other functions.
9.If the display slot already has a programmed function, the display shows FEATURE ON BUTTON. Press the 
or 
keys until Repla, Keep and Delet are shown along the
•Press Repla 
to replace that existing function with the one just programmed. The display then shows BUTTON PROGRAMMED! as above.
•Press Keep 
to keep the existing function and forget the function just programmed.
•Press Delete 
to delete the existing function and forget the function just programmed.
5410/2410 Phone User Guide | Page 27 |
IP Office | Issue 3f (7th October 2005) |