Avaya 15-601082 manual Avpp Configuration, Introduction, Connecting to the Avpp

AVPP Configuration

Introduction

During initial setup of the AVPP, the IP address is established and the maximum number of active calls per access point is set. Optionally, you may enter a hostname and a location for software updates via TFTP.

Note

Where SVP is documented in this section, AVPP applies.

Connecting to the AVPP

The initial connection to the AVPP must be made via a serial connection to establish the AVPP’s IP address. After the IP address is established, connection to the AVPP can be done via the network using Telnet. It is recommended that the basic setup actions occur while the serial connection is made.

Connecting via the Serial Port

1.Using a DB-9 female, null-modem cable, connect the AVPP to the serial port of a terminal or PC.

2.Run a terminal emulation program (such as HyperTerminal™) or use a VT-100 terminal with the following configuration:

Bits per second: 9600

Data bits: 8

Parity: None

Stop bits: 1

Flow control: None

3.To display the AVPP login screen, press Enter.

4.Enter the default login: admin and default password: admin. These are case sensitive. The NetLink SVP-II System menu is displayed.

Wireless Installation and Configuration Guide	Page 14
IP Office	[15-601082] Issue [1] (1 June 2006)