Wireless Phone Installation
Introduction
This section contains information on the installation and configuration of the wireless phone on IP Office. IP Office acts as a routing mechanism for all wireless phones on its system. Information is routed from the phone to IP Office and to the AVPP.
The AVPP is the Quality of Service (QoS) mechanism that is implemented in the wireless phone and access point to enhance voice quality. AVPP gives preference to voice packets on the wireless medium, increasing the probability that all voice packets are transmitted efficiently. These voice packets are then
The IP Office units currently supported with the wireless phones:
• Avaya IP Office 403
• Avaya IP Office 406 (V1 and V2)
• Avaya IP Office 412
Avaya IP Office – Small Office Edition can be optioned as an 802.11b access point (WiFi pcmcia card and IP400 ACCESS POINT RFA license, to activate the access point software) but without QoS. The access point is configurable via IP Office Manager.
Other wireless solutions are available for the IP Office – Small Office Edition.
Notes
The setup for the 3600 series wireless phones requires four major steps:
1.The configuration of the AVPP.
2.The configuration of IP Office.
3.The configuration of the Access Points.
4.The configuration of the 3616/3620/3626 wireless phones.
With IP Office,’ the access point resides on the LAN and is configured based on the manufacturer s guidelines and manuals. For a list of access points supported, go to www.spectralink.com/consumer/resources/wifi_compatibility.jsp.
Wireless Installation and Configuration Guide | Page 29 |
IP Office |