AT&T 9371 user manual Batteries, Charging the Handset Battery Pack

Page 30

9371_book_1ATT 8/14/01 10:00 AM Page 27

BATTERIES

Charging the Handset Battery Pack

This battery should remain charged up to six days with the ringer turned on and up to 12 days with the ringer off. A fully charged battery provides an average talk time of about five hours.

The battery pack needs charging when:

•A new battery is installed in the handset.

•The phone beeps once every five seconds.

•The screen displays BATTERY LOW and the low battery icon.

Place the handset in the base so the CHARGING light turns on. The battery pack is typically fully charged in eight hours.

You can keep the battery fully charged by returning the handset to the base after each use.

If you repeatedly get a low battery indicator, even after charging overnight, the battery should be replaced.

CAUTION: To reduce the risk of fire or injury to persons or damage to the telephone, read and follow these instructions carefully:

•Use only Replacement Battery 3301 (SKU# 91076).

•Do not dispose of the battery in a fire. The cell might explode. Check with local codes for special disposal instructions.

•Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

•Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and keys. The battery or conductor may overheat and cause harm.

•Charge the battery provided with or identified for use with this product only in accordance with the instructions and limitations specified in this manual.

•Observe proper polarity orientation between the battery and battery charger.

27

Image 30

Contents Draft 8/14/01 Part 1 Important Product InformationAdvanced American Telephones. All rights reserved Contents Before YOU Begin About Caller Identification Caller IDInstallation Before You InstallInstall the handset battery Table/Desk Installation Connect the telephone line cord Connect the power cordAttach belt clip to the cordless handset optional Check for dial tone Charge the handset batterySet the dial mode Set the time and date displayed on handset screenWall Installation Position the wall mount adapter on the baseFollow Steps 3-6 in Table/Desk Installation Mount the base on the wallTelephone Operation Handset Ringer Style/Battery Save Temporary Tone DialingHeadset Jack Operating Range Display Screen MessagesSpeaker Volume MutePage/Intercom Handset LocatorDial the mNumber Telephone MemoryStore a Number in m One Touch MemoryStore a Number in the Directory Edit a Number Stored in the Directory Dial Edit EraseDelete a Number Stored in the Directory Dial a Number Stored in the DirectoryStore a Number in Base Memory Dial a Number in Base MemoryCaller ID Operation About Call HistoryReview Call History Delete a Specific Call Delete Records from Call HistoryDial a Displayed Number Delete All CallsStore a Call History Record in the Directory Set the Clock Audible IndicatorsAnswering System Operation About MailboxesRecord Your Announcement AT the BaseAnswering System Feature Setup Feature SummaryDelete Messages Adjust Playback VolumeListen to, Save & Delete Messages Play MessagesCall Screening/Intercept Record a MemoRemote Access Commands Connect with the Answering SystemVoice Menu Turn system off End remote access callRecord memo Turn system onCharging the Handset Battery Pack BatteriesReplacing the Handset Battery Pack If the phone does not ring when you receive a call Case of DifficultyIf the phone doesn’t work at all, check these items first If you lose a call after changing channels If you hear noise or interference when using the phoneIf you hear other calls while using your phone If messages are incompleteIf you have difficulty hearing messages If CL appears in the Message WindowIf your outgoing announcement isn’t clear Remote Commands Answering SystemPress Machine off press #0again