Initiate Intercom calls

1.While both G4 headsets are turned OFF, turn them ON by pressing and holding their Mobile Button until their Blue Lights flash three times.

2.Make sure that both headsets are now flashing slowly in Blue.

NOTE: Selecting a CHANNEL that is already in use will override the paired headset on that CHANNEL with the newly paired headset.

3.On the first G4 headset, press and hold the CHANNEL “A” BUTTON for at least six seconds until the headset’s BLUE or RED Light begins flashing rapidly, indicating it is in Intercom Pairing mode.

4.Repeat Step 3 for the second headset.

5.Within a few seconds, both headsets will show a solid light for two seconds, indicating that the two headsets are now paired, con- nected and ready for use.

NOTE: If the Pairing process is not completed within two minutes the headset will return to Standby mode.

There are two ways to start an Intercom call with your paired headset while the headset is in Standby mode:

Use	Channel		“B”
	Channel	“A”	Channel
		“A”	Use
First G4 unit			Third G4 Headset
Rider “A”			Rider “C”

Second G4 unit

Rider “B”

In this configuration Rider “B” is paired to Rider “A” and to Rider “C”.

IMPORTANT: Since Rider “B” uses two Bluetooth connections during the conference mode, Rider “B” will be disconnected from the mobile phone or GPS device until the conference mode is terminated. Upon termination, Rider “B” will automatically re-connect to his mobile phone or GPS. Rider “A” and “C” remain connected to their mobile phones or GPS devices during the 3-way intercom call.

Set-up and configuration three-way intercom connectivity

VOICE CONNECT:

Start talking loudly

Once you start talking loudly, an Intercom call will be established with the other paired headset.

The Intercom call will stay on until all partici- pants remain silent for 30 seconds.

CHANNEL BUTTON CONNECT:

Tap the chosen CHANNEL Button once

to add or remove the other headset from an Intercom call.

INTERCOM	PAIRING / CONNEC-	PAIRING MODE LED
CHANNEL	TION BUTTON	INDICATORS
CHANNEL “A”	CHANNEL “A” BUTTON	Rapid RED flashing

CHANNEL “B”	CHANNEL “B” BUTTON	Rapid BLUE flashing

PAIRING BETWEEN THREE PARTICIPANTS (between scala rider G4 models only)

9.10b. THREE-WAY INTERCOM

Adding a third G4 unit to your PowerSet headsets, allows you to conduct 3 way intercom conference calls as follows:

To add a third G4 unit to your PowerSet headsets, you will need to desig- nate one of the two factory paired headsets to serve as Rider “B” (see diagram above). Since the factory paired units use Channel “A”, you must now pair the designated Rider “B” with the third G4 unit (Rider “C”).

16 scala rider® G4™ PowerSet