Cardo G4 manual FM Radio, Searching for and setting new stations, Saving a selected station

Page 11

7.THESOUNDOFMUSIC: BUILT-INFMRADIO ANDEXTERNALMP3PLAYER(CABLEOPTION)

7.1 FM RADIO

The scala rider G4 is equipped with a FM stereo radio receiver and RDS (Radio Data System) technology,

allowing you to choose how and when you listen to your favorite stations.

Turn on Radio

While in Standby mode, press and hold CHANNEL

 

“B” button for 3 seconds

 

 

Turn off Radio

While listening to the Radio, press and hold

 

CHANNEL “B” button for 3 seconds

 

 

Switch to next

While listening to the Radio, tap the CHANNEL “B”

preset station

button to cycle through the 6 Preset FM Stations

 

 

Start Intercom call

While listening to the Radio, start talking loudly

 

 

Initiate Voice Dial

While listening to the Radio, tap the Mobile Button

from your Mobile

and pronounce loudly the name of the person you

Phone

wish to call. This feature is supported only by mobile

 

phones that include the Voice Dial feature

 

 

Initiate Redial from

While listening to the Radio, tap the Mobile

your Mobile Phone

Button twice

 

 

RDS ON/OFF

While the Radio is on, press and hold Volume Up

(Default: OFF)

and Volume Down Buttons simultaneously for 3

 

seconds

 

 

Thanks to the RDS feature, your headset will automatically select the strongest signal available for the FM station you wish to listen to, no matter where you are riding. This allows you to leave your hands on the handlebars at all times with no need to adjust the radio station frequency while you are in motion.

RDS ON/OFF (press simultaneously 3 seconds while rado is on)

• ON/OFF FM Radio (press 3 sec.)

• Switch among pre-saved stations (tap briefly)

Searching for and setting new stations

1.While the Radio is on, press and hold the Volume Up or Volume Down Button for three seconds or until you hear the next station on your headset.

•Pressing Volume Up will search upwards (higher frequency).

•Pressing Volume Down will search downwards (lower frequency).

2.Once a station is found, searching stops and you can hear the station.

3.To continue searching, press the Volume Up or Volume Down Button again for three seconds.

4.To save this station, refer to the following section. You may still con- tinue to listen to the current unsaved station.

Saving a selected station

1.Select the station number from one to six that you wish to set by tap- ping the CHANNEL “B” button until the desired station is found.

English

scala rider® G4™ PowerSet

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents User Guide Table of Contents As a stereo headset for listening to the built-in FM Radio Additional Special FeaturesIntroduction Charging the Headset Contents of the Retail BOXSpoken Status Announcements Basic Setup and ConfigurationDisable/Enable status announcements Press and hold General FunctionsMounting the Headset on the Helmet Firmware Upgrade OptionResetting Your Headset Getting StartedPositioning the Microphone and Speakers Attaching and Removing the Headset from Helmet Clamp Using the FLIP-UP AntennaGPS Device Pairing the Headset to a Bluetooth Mobile PhonePairing the Headset to a GPS Device Mobile PhoneOperating your A2DP source from your headset MP3 Music Wireless Option A2DPPairing the Headset to AN MP3 Player or Adapter A2DP and Avrcp profiles mostly 3rd generation devicesSaving a selected station Searching for and setting new stationsFM Radio Initiating and Receiving Mobile Phone Calls Using the Mobile PhoneBackwards Compatibility Using the IntercomStatus Lights IntroductionReceiving Intercom Calls Select your preferred Pairing OptionInitiate Intercom Calls Troubleshooting the Intercom ENABLE/DISABLE Voice Connect Feature VOXReset Pairing Restoring the Original Default Configuration Initiate Intercom calls Set-up and configuration three-way intercom connectivity10c. FOUR-WAY Intercom Pairing Four Scala Rider G4 HeadsetsStep Three Pair Passenger 2 to Passenger 4 via Channel B Both headsets should now be flashing slowly in BlueUsing the G4 for Intercom with Other SCALA RIDER Headsets Step Two Pair Driver 3 to Passenger 4 via Channel a11b. TWO-WAY Intercom with earlier scala rider models 11a. TWO-WAY Intercom with scala rider Q2Initiate Intercom calls from scala rider G4 Initiate Intercom calls from scala rider Q2 Initiate Intercom calls from earlier scala rider headsets11c. Three WAY Intercom with other scala rider headsets Using your scala rider G4 with two scala rider Q2 headsetsPhone USA and Canada + International +4989 450 SupportFor additional information please visit our website at Or contact us at support@cardosystems.comDeclaration of Conformity DOC Operation is subject to the following two conditionsIC RF Radiation Exposure Statement European CE Notice Limitation of Liability Disclaimer of Warranty
Top Page Image Contents