Cardo G4 manual Attaching and Removing the Headset from Helmet Clamp, Using the FLIP-UP Antenna

Page 8

5.4ATTACHING AND REMOVING THE HEADSET FROM THE

HELMET CLAMP

ATTACHING:

Slide the headset sideways (i.e. horizontally) along the sliding panel until a clicking sound indicates that the headset is locked in place.

slide headset sideways

REMOVING:

Your headset can be removed for charging or for storage by sliding the headset sideways.

push headset with your thumb

5.5USING THE FLIP-UP ANTENNA

The flip-up antenna allows you to achieve the maximum intercom range between bikers. To open the antenna, press gently against the protruding tab (at the tip of the antenna) towards the direction of the helmet.

The internal spring will then cause the antenna to flip up.

To close the antenna, push it backwards into its horizontal state until it is locked in place.

NOTE: The sole purpose of the antenna is to increase intercom range between bikers. There is no need to open it when using your mobile phone, FM Radio or MP3 Player but you can do so without concern

6.CONNECTING BLUETOOTH ENABLED MOBILE PHONES, GPS OR MP3 (A2DP) DEVICES

Multiple Device Connectivity (“MDC”) with Bluetooth compatible Devices

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

GPS

 

 

MP3

 

Mobile phone &

Built-in

 

 

 

 

 

A2DP connectivity

FM radio

 

 

 

 

 

 

player

Driver-to-Passenger

 

 

 

 

 

 

 

Driver-to-Passenger

Full Duplex

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Full Duplex

Intercom

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Intercom Connection

Connection

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

scala rider G4 or other

Up to 1 mile / 1.6 km Bike-to-

 

 

 

scala rider headset

 

Bike Intercom Range*

 

 

 

Between 3 separate bikers or

2 couples on

2 motorcycles

Thanks to MDC technology each G4 headset offers parallel connectivity as follows: With up to two other scala rider headsets and with one of the following Bluetooth devices listed below*:

Mobile Phone (either directly or via a GPS device)

GPS device

A2DP enabled MP3 Player or Adapter

Bluetooth Adapter

NOTE:

If you plan to use your mobile phone while using a Bluetooth GPS device, then you should pair your mobile phone to the GPS and not to the G4 headset.

* see restrictions under 9.10 b

8 scala rider® G4PowerSet

Image 8
Contents User Guide Table of Contents As a stereo headset for listening to the built-in FM Radio Additional Special FeaturesIntroduction Contents of the Retail BOX Charging the HeadsetBasic Setup and Configuration Disable/Enable status announcements Press and holdGeneral Functions Spoken Status AnnouncementsFirmware Upgrade Option Resetting Your HeadsetGetting Started Mounting the Headset on the HelmetPositioning the Microphone and Speakers Using the FLIP-UP Antenna Attaching and Removing the Headset from Helmet ClampPairing the Headset to a Bluetooth Mobile Phone Pairing the Headset to a GPS DeviceMobile Phone GPS DeviceMP3 Music Wireless Option A2DP Pairing the Headset to AN MP3 Player or AdapterA2DP and Avrcp profiles mostly 3rd generation devices Operating your A2DP source from your headsetSaving a selected station Searching for and setting new stationsFM Radio Using the Mobile Phone Initiating and Receiving Mobile Phone CallsUsing the Intercom Status LightsIntroduction Backwards CompatibilityReceiving Intercom Calls Select your preferred Pairing OptionInitiate Intercom Calls Troubleshooting the Intercom ENABLE/DISABLE Voice Connect Feature VOXReset Pairing Restoring the Original Default Configuration Set-up and configuration three-way intercom connectivity Initiate Intercom callsPairing Four Scala Rider G4 Headsets 10c. FOUR-WAY IntercomBoth headsets should now be flashing slowly in Blue Using the G4 for Intercom with Other SCALA RIDER HeadsetsStep Two Pair Driver 3 to Passenger 4 via Channel a Step Three Pair Passenger 2 to Passenger 4 via Channel B11b. TWO-WAY Intercom with earlier scala rider models 11a. TWO-WAY Intercom with scala rider Q2Initiate Intercom calls from scala rider G4 Initiate Intercom calls from earlier scala rider headsets 11c. Three WAY Intercom with other scala rider headsetsUsing your scala rider G4 with two scala rider Q2 headsets Initiate Intercom calls from scala rider Q2Support For additional information please visit our website atOr contact us at support@cardosystems.com Phone USA and Canada + International +4989 450Operation is subject to the following two conditions IC RF Radiation Exposure StatementEuropean CE Notice  Declaration of Conformity DOCDisclaimer of Warranty Limitation of Liability