Initiate Intercom calls from scala rider Q2, Example

Initiate Intercom calls from scala rider Q2

MC Button Connect: Tap twice the MC Button to open an intercom call (wait 3 seconds between taps). To terminate the call, tap once.

Initiate Intercom calls from earlier scala rider headsets

CTRL Button Connect: Tap the headset CTRL Button to open/close intercom call

9.11c. THREE WAY INTERCOM (with other scala rider headsets)

Both scala rider G4 headsets included in your retail box are factory paired. In terms of range, the 3-Way Intercom between your G4 and other scala rider units achieves distances of the lowest common denominator. For example, connecting your G4 with two Q2 units will enable intercom distances of maximum 500 m / 540 yards.

NOTE: When connected to earlier scala rider headsets (e.g. a “Solo”, “FM”, or a “TeamSet” Driver unit) only Rider-to-Passenger mode is available.

All options are in Full Duplex, meaning that all parties can speak and hear one another simultaneously, similar to mobile or landline phone conversations and unlike walkie-talkie communications

Using your scala rider G4 with two scala rider Q2 headsets:

Proceed with setup as in section 9.11a above and use either in Rider- to-Passenger or in Bike-to-Bike mode.

Using your G4 and scala rider Q2 with either a Solo, FM, or TeamSet (Driver) headset:

1.Pair your G4 with the Q2 as described in section 9.11a., using CHANNEL “A”.

2.Pair your G4 with the FM as described in section 9.11b., using CHANNEL “B” (For Rider-to-Passenger use only)

Using the scala rider G4 PowerSet with another scala rider model

(such as a Q2, Solo, FM, or TeamSet [Driver] headset)

NOTE: The scala rider G4 PowerSet package, contains two factory paired G4 headsets. I f you did not change the original pairing settings, you can skip step one below.

1.Proceed with setup as in section 9.10a above for pairing the second G4.

2.Proceed with setup as in section 9.11a or 9.11b above according to the headset you want to use.

Example:

For pairing your G4 with another G4 and a scala rider FM headset:

1.Pair your G4 with the second G4 as described in section 9.10a., using CHANNEL “A”.

2.Pair your G4 with the FM as described in section 9.11b., using CHANNEL “B” [For Rider-to-Passenger use only]

Initiate Intercom calls from scala rider G4

There are two ways to start an Intercom call with your paired headsets while the headset is in Standby mode:

Q2: Proceed with setup as in section 9.11a above and use in Bike-to- Bike mode.

Solo, FM, or TeamSet (Driver): Proceed with setup as in section 9.11b above but use only in Rider-to-Passenger mode

Example:

For pairing your G4 with a Q2 and an FM headset:

VOICE CONNECT:

Start talking loudly

Once you start talking loudly, an Intercom call will be established with both paired headsets, CHAN- NEL “A” and CHANNEL “B” (if both are available).

CHANNEL BUTTON CONNECT:

Single tap the CHANNEL “A” But- ton to add or remove the CHANNEL “A” headset from an Intercom call.

Single tap the CHANNEL “B” But- ton to add or remove the CHANNEL “B” headset from an intercom call.

20 scala rider® G4™ PowerSet