4.Snap one end of the coiled handset cord into the Handset jack (5 in
Figure 5). This jack is labeled . Thread the cord into the channel leading to the side edge of the voice terminal (4 in Figure 5).
5.Turn the telephone right side up, with the front facing you.
6.Snap the free end of the handset cord into the handset and place the handset in the cradle.
7.Snap the free end of the line cord into the modular wall jack.
8.Lift the handset and listen for dial tone. If there is no dial tone, check all wire connections to make sure they are secure.
Wall Installation
Note: For
If you are
1.Make sure the
2.Do the following to reverse the handset hook. (The handset retainer is located under the handset as shown in a in Figure 6.)
—In order to release the handset retainer hook, press down on the hook and slide it toward the top of the telephone. (See b in Figure 6.)
—Rotate the hook 180 degrees (as in c in Figure 6) and then slide it back into its slot so the bottom part now sticks out from the top. (See d in Figure 6.) Snap the hook firmly into place.
a.b.
c.
¾
d.
FIGURE 6 Removing, Rotating, and Replacing the Handset Retainer
14