Furuno FM-3000 manual Setting Tag Channels, Starting a Scan, Scan starts

4.Scan Operation

4.2 Setting Tag Channels

For more efficient scanning, add desired channels as tag channels or clear tag channels for unwanted channels. Chan- nels not tagged will be skipped during scanning. Tag chan- nels can be assigned to each channel group (U.S.A., Interna- tional, Canada) independently.

qWhile pushing [HI/LO], push [CH/WX] ( DW U/I/C ) one or more times to select the desired channel group.

wSelect the desired channel to be set as a tag channel. e Push [SCAN] ( TAG ) for 1 sec. to set the displayed channel

as a tag channel.

•“TAG” appears in the display.

rTo cancel the tag channel setting, repeat step e.

• “TAG” disappears.

Convinient: Clearing (setting) all tagged channels

➥While pushing [HI/LO], push [SCAN] ( TAG ) for 3 sec. (until a long beep changes to 2 short beeps) to clear all tag chan- nels setting in the channel group.

•Repeat above procedure to set all tag channels.

4.3 Starting a Scan

Set scan type (Priority or Normal scan) and scan resume timer in advance using Set mode. (p. 38)

qSet tag channels as described at left.

wMake sure the squelch is closed to start a scan.

eWhile pushing [HI/LO], push [CH/WX] ( DW U/I/C ) one or more times to select the channel group, if desired.

rPush [SCAN] to start Priority or Normal scan.

•“Pri Scan 16” or “Normal Scan” appears in the function display.

•When a signal is detected, scan pauses until the signal disap- pears or resumes after pausing 5 sec. according to Set mode setting. (Channel 16 is still monitored during Priority scan.)

•Rotate [CHANNEL] to check the scanning tag channels, to change the scanning direction or resume the scan manually.

•“16” blinks and a beep tone sounds when a signal is received on Channel 16 during Priority scan.

tTo stop the scan, push [SCAN].

[Example]: Starting a Normal scan.

	INT	Push	INT	BUSY	INT
25W		25W		25W
TAG	DUP	TAG	DUP	TAG	DUP
INTL		Normal scan		Normal scan
			Scan starts.	When a signal is received

12