Polycom IP 300 SIP manual Safety and Compliance

Page 23

Safety and Compliance

Part 15 Rules

This device is compliant with Part 15 of the FCC Rules. Operation is subject to the fol- lowing two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interferences received, including interference that may cause unde- sired operation.

Class B Digital Device or Peripheral

Note: This equipment is tested and com- plies with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer- ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1.Reorient or relocate the receiving antenna.

2.Increase the separation between the equipment and receiver.

3.Connect the equipment into an outlet on a circuit different from that to which the receiver is con- nected.

4.Consult the dealer or an experi- ence radio/TV technician for help.

Modifications

In accordance with Part 15 of the FCC Rules, the user is cautioned that any chang- es or modifications not expressly approved

by Polycom, Inc. could void the user’s authority to operate the equipment.

Installation Instructions

Installation must be performed in accor- dance with all relevant national wiring rules.

L’Installation doit être exécutée confor- mément à tous les règlements nationaux applicable au filage électrique.

Plugs Acts as Disconnect Device

The socket outlet to which this apparatus is connected must be installed near the equip- ment and must always be readily accessible.

La prise électrique à laquelle l’appareil est branché doit être installée près de l’équipement et doit toujours être facile- ment accessible.

20

Image 23
Contents User Guide SoundPoint IP 300 SIP Contents Limitation Liability Troubleshooting Safety and ComplianceService Agreements Limitations of Liability Introduction Parts ListIn-Line Power Option Installing SoundPoint IP 300 SIPConnecting Network and Power Source AC Power OptionAttaching the Base Connecting the Handset and Optional HeadsetFeatures Description Key DescriptionsUsing the Headset Using SoundPoint IP 300 SIPUsing the Handset Using Listen ModeMicrophone Mute Answering a CallCall Hold Transferring a Call General Key UseLocal Conferencing Redial Call TimerVolume Adjustment Ending a CallTime and Date Headset Memory ModeDo Not Disturb See also Distinctive Ringing / Call Treatment Display ContrastRing Type Call ListsTo add or edit a contact Contact ListEdit Speed DialMultiple Lines Shared Lines Multiple Call AppearancesTo read text messages Voicemail and Voice and Text MessagingPresence / Status / Buddy Lists Distinctive Ringing / Call TreatmentSee Voicemail and Voice and Text Messaging Phone RebootInstant Messaging No Ringing TroubleshootingNo Dial-Tone No Display, Incorrect Display or Bad ContrastDisplay shows Network Link is Down No Response from Feature Key PressesNo Audio on Headset Safety and Compliance CE and Vcci Mark Polycom Limited Warranty and Limitation LiabilityIndustry Canada IC Limitations of Liability Warranty ExclusiveService Agreements ExclusionsCopyright Notice DisclaimerGoverning Law Page Polycom, Inc Barber Lane Milpitas, CA