About the priority
The order of priority for actions (communication, calling, paging, monitoring, etc.) is as follows, depending on the priority setting.
Priority | Setting | Action |
1 (high) | [URGENT], [BROADCAST]*1 | Communication, |
2 | [PRIORITY] | calling, paging, |
3 | [NORMAL] | chime paging. |
| ||
4 (low) | - | Monitoring, scan- |
|
| monitoring |
*Earlier call has priority over later call if the priority setting is the same.
*Communication takes priority over calling.
However, when a call with higher priority comes in, the communication will be forcibly stopped.
*1: [BROADCAST]:
This can be selected only when you perform paging. When [BROADCAST] is selected, you can perform paging while interrupting all the other communications of lower priority. In that case, no receiver can answer you. For IP units that are in communication, calling or being called when paging with [BROADCAST] is performed, they will turn into the standby mode after paging.
14