Aiphone IS-SOFT operation manual Searching for a station, zone or remote site from the list

Searching for a station, zone or remote site from the list

ASearching for a station or zone in your site by entering the name [NAME SEARCH]

1Select [NAME SEARCH] either in the standby mode (→P. 19) or the SEARCH LIST. (→P. 20)

2Click to display the Dial keys window.

3Enter a name by using the dial keys.

e.g.)

When searching for "MASTER004"; Click the dial keys as follows.

	(4 times)			(twice) (3 times) (8 times) (8 times) (4 times)
M A		S	T	E	R	0	0	4

The entered characters are displayed here.

All the station and/or zone names that include the entered characters in your site are displayed in the list.

*The search is narrowed down whenever a character is added.

NOTE:
You can also select a station from the list by using	after
you select [NAME SEARCH] in step 1.

To delete the just entered character:

Click .

To enter the same characters or characters on the same dial key sequentially:

(e.g.: To enter “AB”)

1.Enter “A”. (Click the dial key once.)

2.Click .

3.Enter “B”. (Click the dial key twice.)

4 Click to select the target station or zone (so that it is highlighted) from the list.

*You can select up to 5 stations and/or zones by clicking . (See below.)

5 Start calling (talking), monitoring or paging by following the procedure for the corresponding performance. (→P. 25-27)

To select two or more stations and/or zones from the list:

1) Click with the target station or zone

highlighted.

The station or zone is checked.

*Click again to clear the check.

2)Repeat step 1) to select more stations and/or zones.

*You can select up to 5 stations and/or zones.

To select 5 stations and/or zones, after checking 4 stations and/or zones, select the 5th one so that it is highlighted. (The 5th station or zone is not checked.)

*You cannot select two or more remote sites.

GETTING STARTED USING THE PC MASTER STATIONAPPENDIX

21