Appendix A. | Section |
6.When Password> is displayed, type the
7.After the DBS responds with REMT>, type P and then press Enter.
8.Follow the directions on the screen to access the desired program. (See “Terminal Programming Commands”.)
ISDN Programming Flexibility
Description
The previous versions did not allow the programming flexibility to accommodate certain central office ISDN configurations. This enhancement allows the flexibility in programming to set the DBS parameters to match certain central office provisioning.
Programming
The following programming addresses are no longer valid:
Name | Key Sequence |
|
|
|
|
ISDN CO Type |
| |
|
| |
|
|
|
Network Type | ||
| ||
|
|
|
Auto Progress | ||
| ||
|
|
|
SDN/MEGACOM | ||
| ||
|
|
|
ISDN Upgrade Procedure:
1.New COP 1.07A is required on Primary Rate card(s).
2.Set system for ISDN function:
(1)
Page | DBS Manual - Revised April 2000 |