Philips 954 Set for Two or Three Phone Lines, Set Up for a Private Line, Change Battery Display

Page 14

TELEPHONE FEATURE SETUP

Set for Two or Three Phone Lines

If you’re not using all four phone lines, you need to turn off the line status for the unused line. If you expand to a third or fourth line, turn the line status back on. You cannot turn off line status for Line 1.

1Press G, *, #.

2Press 2for Line 2

— OR —

Press 3for Line 3

— OR —

Press 4for Line 4.

3Press 0to turn off line status

— OR —

Press 1to turn on line status.

4Press T. You’ll hear a confirmation ring.

Set Up for a Private Line

This feature works only if you have three phone lines connected. Line 4 may vary from phone to phone, so you can consider this a private line that other 954 phones cannot access.

NOTE: The phone number for Line 1 must be the same on all phones for the intercom and paging features to work.

1Press G, *, #.

2Enter a different line number (05–08) for each private line.

3Press and release H. You’ll hear a confirmation ring.

Change BATTERY Display

When battery power is low, the screen flashes BATTERY. Replace the batteries promptly to prevent memory loss (see the INSTALLATION section in this manual). You can set the phone so the screen won’t display the BATTERY message.

1Press G, *, #, *.

2Press and release 0to prevent BATTERY display

— OR —

Press and release 1to enable BATTERY display.

3Press and release C. You’ll hear a confirmation ring.

11

Lucent 0954 book.L1

11

5/7/98, 10:35 AM

Image 14

Contents BUYMEBUYME.COM User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Install 3 AAA batteries InstallationTable/Desk Installation Connect the telephone line cords to the telephoneCheck for dial tone Connect the power adapterConnect the handset cord Wall Installation Reverse the handset tabConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Assign Intercom Number Telephone Feature SetupSet Dial Mode Set the ClockSet for Two or Three Phone Lines Set Up for a Private LineChange Battery Display Operation Line-In-Use Lights Making a CallCall Privacy Ringer Volume VolumeHandset/Speakerphone Volume Control Turning Ringer OffAuto Redial Switch Between LinesRedial HoldTemporary Tone Dialing MuteFlash Conference CallsTransferring an Announced Call Do Not DisturbTransfer a Call Transferring an Unannounced CallTimer Telephone Memory Storing Numbers in Memory Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing a Pause in a Memory NumberIntercom Operation Answering an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Ending an Intercom Call orMaking an Intercom Conference Call Paging All PhonesAnswering an Allpage Room MonitorCase of Difficulty Operation During a Power Failure Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Centrex Operation Setup ChecklistSetting Up a Fourth Line for Each Station Enabling/Disabling Attendant StationAttendant Operation Setting Ring Delay DurationAnswering a Delayed Ring Picking Up Another Station’s Line