Philips 954 manual Directory Card, Storing Numbers in Memory, Storing a Pause in a Memory Number

Page 23

TELEPHONE MEMORY

Directory Card

Remove the directory card and write in the numbers (or names) you want to store in each memory location.

Storing Numbers in Memory

1Press and release G.

2Enter the telephone number you want to store (up to 16 digits)

— OR —

Press and release Rto store the last number dialed.

3Press the memory button where you want to store the number

— OR —

Press land the memory button where you want to store the number.

Storing a Pause in a Memory Number

To store a dialing pause in a memory number, press and release Pwhere you want the dialing pause to occur. Each time you press P, you enter a two-second pause in the dialing sequence.

Storing a Temporary Tone Signal in a Memory Number

To store a tone signal, press and release twhere you want tone dialing to begin. All digits entered after this will send tone signals.

Storing Flash in a Memory Number

You can store the switchhook flash needed to access some custom-calling services in a memory number. Press and release Fwhere you want the switchhook flash to occur in the dialing sequence.

Erasing Memory Numbers

To remove a number from memory, you can store another number in its place. To clear a memory location and leave it empty:

1Press and release G.

2Press and release P.

3Press the memory location to be erased

— OR —

Press land the memory location to be erased.

20

Lucent 0954 book.L1

20

5/7/98, 10:36 AM

Image 23

Contents BUYMEBUYME.COM User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Connect the telephone line cords to the telephone InstallationTable/Desk Installation Install 3 AAA batteriesCheck for dial tone Connect the power adapterConnect the handset cord Reverse the handset tab Wall InstallationConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set the Clock Telephone Feature SetupSet Dial Mode Assign Intercom NumberSet for Two or Three Phone Lines Set Up for a Private LineChange Battery Display Operation Line-In-Use Lights Making a CallCall Privacy Turning Ringer Off VolumeHandset/Speakerphone Volume Control Ringer VolumeHold Switch Between LinesRedial Auto RedialConference Calls MuteFlash Temporary Tone DialingTransferring an Unannounced Call Do Not DisturbTransfer a Call Transferring an Announced CallTimer Telephone Memory Storing a Pause in a Memory Number Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing Numbers in MemoryIntercom Operation Ending an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Answering an Intercom Call orRoom Monitor Paging All PhonesAnswering an Allpage Making an Intercom Conference CallCase of Difficulty Cannot Use DND, TIMER, Allpage or SET Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Operation During a Power FailureExpanding the 954 System Enabling/Disabling Attendant Station Setup ChecklistSetting Up a Fourth Line for Each Station Centrex OperationAttendant Operation Setting Ring Delay DurationAnswering a Delayed Ring Picking Up Another Station’s Line