Philips 954 Telephone Does Not Ring, Intercom Paging Signal Not Received, Line Lights Remain On

Page 28

IN CASE OF DIFFICULTY

Telephone Does Not Ring

•Make sure the Do Not Disturb (DND) feature is not activated.

•Make sure ringers are turned on.

•If there are several non-system phones on the line that doesn’t ring, disconnect some of them. Having too many phones connected can also result in low ringer volume for non-system telephones.

•If the INTERCOM light flashes but you don’t hear a paging signal, make sure the Do Not Disturb feature is not activated.

Intercom Paging Signal Not Received

Make sure you have programmed your intercom station number correctly.

Cannot Join a Conversation in Progress

The privacy feature prevents another set on the system from interrupting a conversation. Make sure you press the line button to release privacy.

Line Lights Remain On

If the line lights remain on even if no line is connected, make sure the system is programmed for that line to be absent. See “Set for Two or Three Phone Lines” in the TELEPHONE FEATURE SETUP section of this manual.

Tone Signals Do Not Activate a Remote Device

•Tone signaling does not work during conference calls.

•The phone generates tones of fixed duration, which may not be long enough to activate some devices such as answering machines.

Answering Machine Does Not Answer

Telephone answering machines must connect directly to the line. If you have a two-line answering machine, it must connect to a two-line jack, or to two jacks on different lines.

Operation During a Power Failure

This phone does not operate during a power failure.

Cannot Use DND, TIMER, ALLPAGE or SET

Make sure lis not turned on. If LOWER is displayed, press lto turn it off.

25

Lucent 0954 book.L1

25

5/7/98, 10:36 AM

Page 27 Page 29
Image 28
Page 27 Page 29
Contents BUYMEBUYME.COM User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Installation Table/Desk InstallationInstall 3 AAA batteries Connect the telephone line cords to the telephoneConnect the handset cord Connect the power adapterCheck for dial tone Wall Installation Reverse the handset tabConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Telephone Feature Setup Set Dial ModeAssign Intercom Number Set the ClockChange Battery Display Set Up for a Private LineSet for Two or Three Phone Lines Operation Call Privacy Making a CallLine-In-Use Lights Volume Handset/Speakerphone Volume ControlRinger Volume Turning Ringer OffSwitch Between Lines RedialAuto Redial HoldMute FlashTemporary Tone Dialing Conference CallsDo Not Disturb Transfer a CallTransferring an Announced Call Transferring an Unannounced CallTimer Telephone Memory Storing a Temporary Tone Signal in a Memory Number Directory CardStoring Numbers in Memory Storing a Pause in a Memory NumberIntercom Operation Basic Intercom Operations Making an Intercom Call orAnswering an Intercom Call or Ending an Intercom Call orPaging All Phones Answering an AllpageMaking an Intercom Conference Call Room MonitorCase of Difficulty Intercom Paging Signal Not Received Tone Signals Do Not Activate a Remote DeviceOperation During a Power Failure Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Setup Checklist Setting Up a Fourth Line for Each StationCentrex Operation Enabling/Disabling Attendant StationAnswering a Delayed Ring Setting Ring Delay DurationAttendant Operation Picking Up Another Station’s Line
Top Page Image Contents