Philips 954 manual Case of Difficulty

Page 27

IN CASE OF DIFFICULTY

If this telephone does not work properly, try the following suggestions. If you’re still having problems, call 1 800 PCC–9125.

No Dial Tone

•Make sure all plugs are connected properly. Inspect the line cord connections at the modular jack and at the telephone. Also inspect the coiled handset cord connection at both ends.

•Check to make sure the phone is not on hold.

Call Cannot Be Dialed or is Dialed Slowly

This product comes set to touch tone mode. If you have dial pulse (rotary) dialing service, you cannot dial numbers with the phone set to touch tone. See the TELEPHONE FEATURE SETUP section of this manual to set the dial mode to PULSE.

Interference on Intercom or Phone Calls

This phone uses sensitive circuitry that may pick up interference in environments with excessive electrical noise. To minimize interference, keep electrical noise sources away from telephone wiring and sets.

Telephone Lights Flutter Continuously

•Power may have been interrupted.

•If AC power is controlled by a wall switch, make sure the switch is turned on.

•Check the power cords on all system phones, and check the fuse or circuit breaker that serves the phones.

•Check the telephone jack by disconnecting the 954 and connecting another non-system telephone.

•Check that all line assignments are correct, and that all 954 phones are on the line designated as Line 1.

Difficulty Storing Numbers in Memory

•Make sure you are pressing the correct sequence of buttons for storing one-touch and two-touch numbers.

•Make sure the telephone is idle while you are storing numbers. If you lift the handset or press Kwhile storing numbers, the number will be entered incorrectly.

24

Lucent 0954 book.L1

24

5/7/98, 10:36 AM

Page 26 Page 28
Image 27
Page 26 Page 28
Contents BUYMEBUYME.COM User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Connect the telephone line cords to the telephone InstallationTable/Desk Installation Install 3 AAA batteriesConnect the power adapter Connect the handset cordCheck for dial tone Reverse the handset tab Wall InstallationConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set the Clock Telephone Feature SetupSet Dial Mode Assign Intercom NumberSet Up for a Private Line Change Battery DisplaySet for Two or Three Phone Lines Operation Making a Call Call PrivacyLine-In-Use Lights Turning Ringer Off VolumeHandset/Speakerphone Volume Control Ringer VolumeHold Switch Between LinesRedial Auto RedialConference Calls MuteFlash Temporary Tone DialingTransferring an Unannounced Call Do Not DisturbTransfer a Call Transferring an Announced CallTimer Telephone Memory Storing a Pause in a Memory Number Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing Numbers in MemoryIntercom Operation Ending an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Answering an Intercom Call orRoom Monitor Paging All PhonesAnswering an Allpage Making an Intercom Conference CallCase of Difficulty Cannot Use DND, TIMER, Allpage or SET Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Operation During a Power FailureExpanding the 954 System Enabling/Disabling Attendant Station Setup ChecklistSetting Up a Fourth Line for Each Station Centrex OperationSetting Ring Delay Duration Answering a Delayed RingAttendant Operation Picking Up Another Station’s Line
Top Page Image Contents