Philips 954 manual Table/Desk Installation, Install 3 AAA batteries

Page 7

INSTALLATION

Table/Desk Installation

1Install 3 AAA batteries.

•Press in on the tabs and remove the telephone base.

•Press in on the tabs on the battery door, and remove it.

•Insert 3 AAA batteries, and replace the battery door.

•Replace the telephone base.

NOTE: Batteries retain telephone memory in the event of a power failure. If power fails, this phone will not work.

2 Connect the telephone line cords to the telephone.

NOTE: If the phone rings when you first connect the line cords, you need to set the phone’s intercom number. See “Assign Intercom Number” in the TELEPHONE FEATURE SETUP section of this manual.

•Four One-Line Jacks

Modular

Telephone Jacks

Lines 3 and 4

Modular

Telephone Jacks

Lines 1 and 2

Standard

Electrical

Outlet

Telephone Jacks

Telephone	Power Cord
Line Cords

4

Lucent 0954 book.L1

4

5/7/98, 10:34 AM

Image 7

Contents BUYMEBUYME.COM User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Connect the telephone line cords to the telephone InstallationTable/Desk Installation Install 3 AAA batteriesConnect the handset cord Connect the power adapterCheck for dial tone Reverse the handset tab Wall InstallationConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set the Clock Telephone Feature SetupSet Dial Mode Assign Intercom NumberChange Battery Display Set Up for a Private LineSet for Two or Three Phone Lines Operation Call Privacy Making a CallLine-In-Use Lights Turning Ringer Off VolumeHandset/Speakerphone Volume Control Ringer VolumeHold Switch Between LinesRedial Auto RedialConference Calls MuteFlash Temporary Tone DialingTransferring an Unannounced Call Do Not DisturbTransfer a Call Transferring an Announced CallTimer Telephone Memory Storing a Pause in a Memory Number Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing Numbers in MemoryIntercom Operation Ending an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Answering an Intercom Call orRoom Monitor Paging All PhonesAnswering an Allpage Making an Intercom Conference CallCase of Difficulty Cannot Use DND, TIMER, Allpage or SET Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Operation During a Power FailureExpanding the 954 System Enabling/Disabling Attendant Station Setup ChecklistSetting Up a Fourth Line for Each Station Centrex OperationAnswering a Delayed Ring Setting Ring Delay DurationAttendant Operation Picking Up Another Station’s Line