Philips 954 manual Connect the power adapter, Connect the handset cord, Check for dial tone

Page 8

INSTALLATION

Two Two-Line Jacks

Modular

Telephone Jack

Lines 3 and 4

Modular

Telephone Jack

Lines 1 and 2

Telephone Jacks

Standard

Electrical

Outlet

Telephone

Power Cord

Line Cords

 

3Connect the power adapter.

Use only the power adapter provided with this product. To obtain a replacement, call 1 800 PCC–9125.

Plug one end of the power adapter into the jack labeled ADAPTER on the back of the phone. Plug the other end into a standard electrical outlet.

4Connect the handset cord.

Plug one end of the coiled handset cord into the jack on the bottom of the phone. Plug the other end into the handset, and hang up.

5Check for dial tone.

Lift the handset and listen for a dial tone. If you cannot hear a dial tone, turn to IN CASE OF DIFFICULTY in this manual.

5

Lucent 0954 book.L1

5

5/7/98, 10:34 AM

Image 8
Contents BUYMEBUYME.COM User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Installation Table/Desk InstallationInstall 3 AAA batteries Connect the telephone line cords to the telephoneCheck for dial tone Connect the power adapterConnect the handset cord Wall Installation Reverse the handset tabConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Telephone Feature Setup Set Dial ModeAssign Intercom Number Set the ClockSet for Two or Three Phone Lines Set Up for a Private LineChange Battery Display Operation Line-In-Use Lights Making a CallCall Privacy Volume Handset/Speakerphone Volume ControlRinger Volume Turning Ringer OffSwitch Between Lines RedialAuto Redial HoldMute FlashTemporary Tone Dialing Conference CallsDo Not Disturb Transfer a CallTransferring an Announced Call Transferring an Unannounced CallTimer Telephone Memory Storing a Temporary Tone Signal in a Memory Number Directory CardStoring Numbers in Memory Storing a Pause in a Memory NumberIntercom Operation Basic Intercom Operations Making an Intercom Call orAnswering an Intercom Call or Ending an Intercom Call orPaging All Phones Answering an AllpageMaking an Intercom Conference Call Room MonitorCase of Difficulty Intercom Paging Signal Not Received Tone Signals Do Not Activate a Remote DeviceOperation During a Power Failure Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Setup Checklist Setting Up a Fourth Line for Each StationCentrex Operation Enabling/Disabling Attendant StationAttendant Operation Setting Ring Delay DurationAnswering a Delayed Ring Picking Up Another Station’s Line