Philips 954 manual Attendant Operation, Setting Ring Delay Duration, Answering a Delayed Ring

Page 31

CENTREX OPERATION

Attendant Operation

Once another 954 phone has enabled its delayed ring, the attendant phone will receive those calls. All the 954 features work in the same manner as described in the beginning of this manual.

The attendant phone can pick up other Centrex lines through Centrex switching. The attendant can store the Centrex pickup codes and the seven- digit phone number of each station, except for the attendant phone, into memory locations.

Setting Ring Delay Duration

This feature allows other 954 telephones’ calls to ring at the attendant phone. After a specified ring delay, the calls will ring at the attendant phone. For a 10-second delay before the calls ring at the attendant phone, enter 10.

1Press G*#.

2Enter the number of seconds for the ring delay (01–30)

— OR —

Enter 00to cancel Ring Delay.

3Press M. You’ll hear a confirmation ring.

Answering a Delayed Ring

The attendant phone rings and the screen displays the station number of the intercom sending the delayed ring.

1Select a free line.

2Enter the Centrex pickup code.

3Enter the seven-digit phone number of the station sending the delayed ring

— OR —

Press the corresponding memory locations for the Centrex pickup code and the seven-digit phone number for the station sending the delayed ring.

NOTE: If the attendant is using another line and receives a delayed ring, the attendant phone can put the other line on hold and follow Steps 1–3. If the attendant is on an intercom call, the intercom call should be ended before picking up the ringing phone.

28

Lucent 0954 book.L1

28

5/7/98, 10:36 AM

Page 30 Page 32
Image 31
Page 30 Page 32
Contents BUYMEBUYME.COM User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Connect the telephone line cords to the telephone InstallationTable/Desk Installation Install 3 AAA batteriesConnect the handset cord Connect the power adapterCheck for dial tone Reverse the handset tab Wall InstallationConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set the Clock Telephone Feature SetupSet Dial Mode Assign Intercom NumberChange Battery Display Set Up for a Private LineSet for Two or Three Phone Lines Operation Call Privacy Making a CallLine-In-Use Lights Turning Ringer Off VolumeHandset/Speakerphone Volume Control Ringer VolumeHold Switch Between LinesRedial Auto RedialConference Calls MuteFlash Temporary Tone DialingTransferring an Unannounced Call Do Not DisturbTransfer a Call Transferring an Announced CallTimer Telephone Memory Storing a Pause in a Memory Number Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing Numbers in MemoryIntercom Operation Ending an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Answering an Intercom Call orRoom Monitor Paging All PhonesAnswering an Allpage Making an Intercom Conference CallCase of Difficulty Cannot Use DND, TIMER, Allpage or SET Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Operation During a Power FailureExpanding the 954 System Enabling/Disabling Attendant Station Setup ChecklistSetting Up a Fourth Line for Each Station Centrex OperationAnswering a Delayed Ring Setting Ring Delay DurationAttendant Operation Picking Up Another Station’s Line
Top Page Image Contents